Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Rectangular silver ATX power supply unit with fan grille and connector sockets

KHACHIMO

KHACHIMO FSP600-702UH Inspur NF5245 M3 600W power supply

SKU CH-XVPD-DYK9G

A 600W ATX power supply tested working for the Inspur NF5245 M3 server

  • TypeATX
  • 600W output powers demanding server builds
  • ATX form factor fits standard chassis layouts
  • Tested working so it arrives ready to install
  • Built for Inspur NF5245 M3 compatibility

KHACHIMO 600W ATX server supply

The KHACHIMO FSP600-702UH is a new 600 watt ATX power supply built for the Inspur NF5245 M3 platform. It targets system integrators and IT teams who need a direct replacement unit that has been tested working before dispatch. The form factor matches standard ATX dimensions so it fits the designated chassis without modification. Buyers who need redundant or hot-swap modules should look elsewhere because this is a single fixed supply.

Thermals noise and power draw

Under normal load the unit delivers up to 600 watts while its internal fan spins at a speed governed by the platform firmware. Acoustic output stays at a level typical for 1U server power supplies in a rack environment. Power draw from the wall scales with the connected components and the supply’s tested efficiency curve. No separate fan-speed curve or noise figure is published by the manufacturer.

Kohokohdat

  • 600W output powers demanding server builds
  • ATX form factor fits standard chassis layouts
  • Tested working so it arrives ready to install
  • Built for Inspur NF5245 M3 compatibility

Tekniset tiedot

TypeATX

Kysymyksiä tästä tuotteesta

How do I install this 600W ATX power supply into an Inspur NF5245 M3 server?

Align the FSP600-702UH unit with the server's power supply bay, slide it in firmly until the latch clicks, then secure the retention screw. The step often missed is fully seating the unit before tightening the screw, which ensures proper electrical contact.

What maintenance will this 600W power supply need over its service life?

Periodically inspect the intake vents for dust buildup and clean with compressed air to maintain airflow. The internal fan is the primary moving part; if bearing noise develops after extended use, the entire FSP600-702UH unit would typically be replaced.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.