Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

KHACHIMO

KHACHIMO WR-2921-51-AC 2921 2951 Router Power Supply

SKU CH-EMSW-DDXYA

Replacement power supply for Cisco 2921 and 2951 routers, tested before shipment

  • TypeATX
  • Tested before shipment for reliable router operation
  • Compatible with Cisco 2921 and 2951 series routers
  • ATX form factor fits standard power supply slots
  • 51 W output delivers stable power to network equipment

Cisco 2921 and 2951 Router Power Supply

The KHACHIMO WR-2921-51-AC is a replacement ATX power supply built for Cisco 2921 and 2951 series routers. Each unit is tested before shipment to confirm reliable operation. It suits network administrators who need a direct-fit spare for these specific router models.

51-volt output capacity for targeted router support

The supply delivers the 51-volt rail required by the 2921 and 2951 chassis, providing enough headroom for normal routing loads with installed modules. It does not support other Cisco platforms or higher-wattage configurations that demand additional power rails. Builders needing redundant or hot-swap capability should verify chassis compatibility before purchase.

Kohokohdat

  • Tested before shipment for reliable router operation
  • Compatible with Cisco 2921 and 2951 series routers
  • ATX form factor fits standard power supply slots
  • 51 W output delivers stable power to network equipment

Tekniset tiedot

TypeATX

Kysymyksiä tästä tuotteesta

Will the WR-2921-51-AC power supply fit my older Cisco 2921 router chassis?

Yes, the WR-2921-51-AC is built for the Cisco 2921 and 2951 series, so it matches the mounting points and connector layout of those chassis.

How can I confirm the WR-2921-51-AC is delivering power correctly once installed?

After fitting the unit, check that the router powers on normally and the front-panel LEDs show a stable green state without amber alarms.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.