LONGER
LONGER RAY5 20W Laser Engraver & 8MP Lightbum Camera Module
A 20 W laser engraver paired with an 8 MP camera module for visual alignment and monitoring
Option 20W+Lightbum Camera
- 20W+Lightbum Camera
- 20W+Air Assist kit
- 20w + 8 Pcs Riser Pads
- 20W+Roller Kits
- 20W+Rotary Roller
- 20W+Laser Engrave Enclosure
- 20W+Material Pack
- 20W+500*500
- 20W+200*300
- 20W+400*400
- 20W+Y-Axis Expansion Kit
- 20W+Aluminum Cards 100 PCS
Näytä 1 muuta kokoonpanoa
- 20 W laser power delivers deep cutting and fast engraving
- 8 MP Lightburn camera enables precise visual alignment and positioning
- New condition ensures full performance and reliability out of the box
- Combined engraver and camera module streamlines workflow for maker projects
LONGER RAY5 20W Laser Engraver
This 20W laser engraver is built for makers who want a ready-to-use cutting and marking tool. The bundle includes an 8MP Lightburn camera module that helps align artwork on the workpiece. It suits hobbyists and small workshops looking for a combined engraving and visual positioning system.
Sustained 20W output handling
The 20W laser module is designed to maintain its rated power during extended cutting sessions rather than only in short bursts. Effective heat dissipation keeps the diode stable so cut depth stays consistent over long jobs. The camera feed remains usable while the laser runs, letting you monitor alignment without pausing the work. Buyers who need higher optical power for thicker materials should look at more powerful systems.
Kohokohdat
- 20 W laser power delivers deep cutting and fast engraving
- 8 MP Lightburn camera enables precise visual alignment and positioning
- New condition ensures full performance and reliability out of the box
- Combined engraver and camera module streamlines workflow for maker projects
Tekniset tiedot
Tälle tuotteelle ei ole vielä julkaistu teknisiä tietoja.
Tämän mallin muut versiot
5 lisää samasta mallistosta
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Kysymyksiä tästä tuotteesta
How much electrical power does the 20 W laser module draw during extended use?
The laser module is rated at 20 W optical output; actual mains draw will depend on the power supply efficiency and duty cycle, so check the PSU label for the exact wattage.
Which controller board or firmware must my engraver already run for the Lightbum camera module to work?
The Lightbum camera module is designed for the LONGER RAY5 series; it connects to the engraver's existing control board and requires the matching firmware version supplied by LONGER.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
