BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
myVolts
TFX form-factor 275 W unit with 20+4 pin, 4-pin CPU, 3× Molex, floppy and 3× SATA connectors, 80 mm double-ball-bearing fan, 100/240 V input
This TFX form-factor power supply delivers 275 watts and is built as a direct replacement for the HP Compaq Presario CQ4000KL. It suits owners of that slimline desktop who need to restore reliable power after a failure or who want a fresh unit for continued use. The 20+4 pin motherboard connector, 4-pin CPU connector, three Molex, one floppy and three SATA connectors cover the internal devices found in the original chassis.
The unit fits the existing TFX cavity and uses the same screw pattern, so installation follows the normal slimline procedure: remove the side panel, unplug the old cables, swap the unit and reconnect. The 80 mm double ball-bearing fan provides active airflow; the most common issue is forgetting to seat the 4-pin CPU plug or leaving a SATA connector loose, which will prevent boot or drive detection.
Before ordering, confirm the original power supply is rated 200, 250, 300 or 350 watts and that the case accepts a TFX enclosure. Verify the motherboard uses a 20+4 pin main connector and a 4-pin CPU power header, and count the SATA, Molex and floppy devices you plan to power. The input range is 100 to 240 volts, so mains compatibility is broad.
| Type | AT |
|---|
The 80mm double ball-bearing fan should spin steadily and the system should boot without shutdowns under load, confirming the 275W output is stable.
Included are a 20+4 pin motherboard connector, a 4-pin CPU connector, three Molex, one floppy and three SATA leads; no extra cables are required for a standard build.
The 275W unit directly replaces the original 200, 250, 300 or 350W supply; select the 420W version only if you plan to add power-hungry components later.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?