Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

myVolts

myVolts 300 W TFX Power Supply for HP Slimline

SKU CH-RW45-JRT1W

TFX form-factor unit delivering 300 W with 20+4-pin, 12 V P4, SATA, Molex and floppy connectors for listed HP Slimline models

  • TypeAT
  • 300 W upgrade supports extra components in slim desktops
  • TFX form factor fits HP Slimline chassis directly
  • 20+4 pin main connector works with 20 or 24 pin boards
  • 40 mm ball-bearing fan with thermal speed control manages heat quietly
  • Compatible with multiple HP Slimline part numbers for easy replacement

Fits HP Slimline desktops

This 300 W TFX power supply replaces the original unit in HP Slimline models including AY004AA, KY713AA, KY714AA, KY715AA, KY766AA and KY767AA. It delivers higher wattage than the factory supply to support additional internal devices. The compact TFX form factor matches the slim chassis exactly.

Suits owners adding drives or cards.

Builders upgrading a compatible Slimline with extra hard drives, optical drives or a low-profile expansion card will benefit from the extra power headroom. The unit is not suitable for standard ATX or micro-ATX cases that require a full-size PSU. It also cannot support high-end graphics cards that need dedicated PCIe power connectors.

Single 12 V rail rated at 9 A per rail

The label specifies +12V1 at 9 A and +12V2 at 9 A, giving a combined 12 V capacity that limits the graphics card tier you can run. Check your GPU’s power draw against this figure before buying. The supply provides one 20+4 pin main connector, one 4-pin P4 connector, three Molex, three SATA and one floppy lead.

Kohokohdat

  • 300 W upgrade supports extra components in slim desktops
  • TFX form factor fits HP Slimline chassis directly
  • 20+4 pin main connector works with 20 or 24 pin boards
  • 40 mm ball-bearing fan with thermal speed control manages heat quietly
  • Compatible with multiple HP Slimline part numbers for easy replacement

Tekniset tiedot

TypeAT

Kysymyksiä tästä tuotteesta

How do I install the 20+4 pin main connector on an older 20-pin motherboard?

Align the 20-pin section with the motherboard socket and leave the extra 4 pins unplugged; the split design fits both 20-pin and 24-pin boards without adapters.

Which component will likely need replacement first in this unit?

The internal 40mm ball-bearing fan is the only moving part and will wear out before the solid-state circuitry under continuous operation.

What thermal limit appears first during sustained full-load use?

The operating ceiling is 50 °C; once the case interior reaches that temperature the supply can no longer guarantee rated output.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.