Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Pink aluminium switch-mode power supply, open frame with screw terminals

myVolts

myVolts S-720-24 24V 30A 720W AC170-250V pink power supply

SKU CH-66TH-CCFGV

A 720 W AC-to-DC unit that delivers 24 V at 30 A with overload, over-voltage and short-circuit protection for industrial and radio use

  • TypeAT
  • High efficiency with low DC ripple for stable output
  • Built-in short circuit, overload and overvoltage protection
  • 100 % full-load burn-in test ensures reliable operation
  • Excellent insulation strength for safe industrial use
  • Wide AC 170-250 V input suits global mains voltages

720 W 24 V industrial power supply

This 24 V 30 A unit delivers 720 W from a 170–250 V AC input. It is built for industrial automation, LED displays, CCTV, radio, 3D printers and similar equipment that need a stable DC source. The aluminium-alloy housing uses natural convection cooling and carries CCC, FCC and CE compliance. Operating range is 0–40 °C with up to 95 % non-condensing humidity.

Protection and adjustment features

Overload, over-voltage and short-circuit protection shut the output down before damage occurs. A 100 % full-load burn-in at the factory verifies reliability under maximum stress. The +V/ADJ terminal lets you trim the output voltage for fine-tuning sensitive loads. Low DC ripple and high insulation strength keep noise-sensitive circuits clean.

Capacity headroom and limits

At 30 A continuous the supply runs LED bars, printer beds and automation racks with ample margin. It reaches its ceiling when the combined load draws more than 720 W or the ambient temperature exceeds 40 °C. The natural-cooling design means no fan to fail, but also no forced-air headroom for sustained overloads. Buyers needing higher current, wider input range or redundant modules must look beyond this single-unit design.

Kohokohdat

  • High efficiency with low DC ripple for stable output
  • Built-in short circuit, overload and overvoltage protection
  • 100 % full-load burn-in test ensures reliable operation
  • Excellent insulation strength for safe industrial use
  • Wide AC 170-250 V input suits global mains voltages

Tekniset tiedot

TypeAT

Kysymyksiä tästä tuotteesta

Does the S-720-24 have any user-serviceable parts or consumables that will need replacing?

The aluminium-alloy chassis has no fan or filters; only the internal electrolytic capacitors age, and they are not user-replaceable.

Which protection circuit activates first when the S-720-24 is run at its 30 A limit for hours?

Overload protection trips once the output current exceeds 30 A, limiting the supply before thermal stress builds.

How much heat and noise does the fanless S-720-24 produce when powering a 24 V 720 W load all day?

Natural convection dissipates the loss; the case becomes warm to the touch but stays silent because there is no moving parts.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.