Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Sixteen green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 1.5TB DDR5-6400 ECC RDIMM 16x96GB CL52 1.1V Supermicro X14DBG-LC+ memory upgrade

SKU CH-3HSG-61E79

1.5 TB DDR5-6400 ECC registered server memory kit with sixteen 96 GB modules at CL52 and 1.1 V for Supermicro X14DBG-LC+

  • Capacity1.5TB (16 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 1.5TB 16X96GB

Näytä 3 muuta kokoonpanoa
  • Massive 1.5 TB capacity from 16 × 96 GB modules
  • DDR5-6400 speed with CL52 latency for high-throughput workloads
  • Registered ECC design corrects single-bit errors and offloads the memory controller
  • 10 V operation matches the server's voltage requirement exactly
  • 288-pin RDIMM form factor validated for the Supermicro X14DBG-LC+ motherboard

1.5 TB DDR5-6400 ECC RDIMM kit for Supermicro

This 16-module kit delivers 1.5 TB of registered DDR5 memory built to the exact rank, voltage and timing the Supermicro X14DBG-LC+ memory controller expects. Each 96 GB 2Rx4 RDIMM operates at 1.1 V with CL52 latency so the board recognises the full population at rated speed. It targets administrators who need maximum capacity in every slot without manual tuning.

16 x 96 GB 2Rx4 registered ECC at 6400 MT/s

Registered architecture offloads the memory controller so all 288-pin slots run fully populated at 6400 MT/s while on-die ECC corrects single-bit errors before they reach production workloads. The 1.1 V CL52 spec provides headroom for sustained server loads, but the kit cannot exceed the motherboard's validated population rules or supported maximum capacity.

Spec-matched RDIMM form factor for 288-pin DDR5

The modules use the 288-pin RDIMM form factor required by the X14DBG-LC+ and will not fit UDIMM or SODIMM sockets. Builders must consult the board manual for approved DIMM population order and any per-channel limits before installation. No heat spreader is included, so chassis airflow must handle thermal load across all 16 slots.

Kohokohdat

  • Massive 1.5 TB capacity from 16 × 96 GB modules
  • DDR5-6400 speed with CL52 latency for high-throughput workloads
  • Registered ECC design corrects single-bit errors and offloads the memory controller
  • 10 V operation matches the server's voltage requirement exactly
  • 288-pin RDIMM form factor validated for the Supermicro X14DBG-LC+ motherboard

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-9624K16
Capacity1.5TB (16 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content1.5TB 16X96GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will the 1.5TB 16x96GB DDR5-6400 kit run alongside any existing RDIMMs already installed in my Supermicro X14DBG-LC+?

Mixing different capacities, ranks or speeds can prevent the server from booting or force all modules to run at the lowest common settings. For reliable operation, populate all 16 slots with this matched 2Rx4 CL52 1.1V kit.

How can I confirm the 1.5TB kit is recognised at full speed and capacity after installation?

Enter the BIOS or UEFI on the Supermicro X14DBG-LC+ and verify that all 16 slots show 96GB each, total 1.5TB, running at DDR5-6400 with CL52 timings and 1.1V.

Does the 16-module 1.5TB kit include heatsinks or any extra cables, or must I buy them separately?

The package contains only the 16 bare 288-pin RDIMM modules; no heat spreaders, cables or mounting hardware are included.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.