Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR5 UDIMM sticks without heat spreaders, 288-pin, 16GB kit

NEMIX RAM

NEMIX RAM 16GB (2×8GB) DDR5 5600 CL46 1.1V 288-pin UDIMM Kit for Supermicro X14SAE

SKU CH-603B-GN5CW

A 16 GB DDR5 kit with two 8 GB unbuffered UDIMMs rated at 5600 MT/s, CL46 and 1.1 V, validated for the Supermicro X14SAE motherboard

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Size 16GB 2X8GB

  • 16 GB dual-channel kit enables full bandwidth on Supermicro X14SAE
  • DDR5-5600 CL46 at 1.10 V matches the board's rated speed and voltage
  • 288-pin unbuffered UDIMM form factor fits the desktop slots this motherboard requires
  • Built with major OEM chips from Samsung Micron or Hynix for tested stability
  • Lifetime replacement warranty and US-based technical support included

Exact DDR5 match for Supermicro X14SAE

This 16 GB kit delivers two 8 GB DDR5 5600 UDIMMs built to the Supermicro X14SAE motherboard's memory-population rules. The modules are non-ECC and unbuffered, so they install directly into standard desktop DIMM slots without server-grade requirements. Major OEM chips from Samsung, Micron or Hynix provide tested stability at rated speed. Builders upgrading this specific platform receive a drop-in solution that the firmware recognises at full capacity.

1Rx8 rank and CL46 timing decide fit

The single-rank 1Rx8 organisation combined with CL46 latency at 1.10 V matches the exact electrical profile the X14SAE memory controller expects. A different rank structure or latency would prevent the board from training at DDR5 5600, leaving capacity unrecognised or speeds reduced. This specification is the gatekeeper for reliable operation on the target system.

No heat spreader keeps clearance simple

The bare-module design omits a heat spreader, so the kit fits tight DIMM spacing and low-profile CPU coolers without interference. Package contents are limited to the two UDIMMs themselves; no software, cables or additional accessories are included. Installers should consult the motherboard manual for approved population order before seating the modules.

Kohokohdat

  • 16 GB dual-channel kit enables full bandwidth on Supermicro X14SAE
  • DDR5-5600 CL46 at 1.10 V matches the board's rated speed and voltage
  • 288-pin unbuffered UDIMM form factor fits the desktop slots this motherboard requires
  • Built with major OEM chips from Samsung Micron or Hynix for tested stability
  • Lifetime replacement warranty and US-based technical support included

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-818K2
Capacity16GB (2 x 8GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB 2X8GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will the DDR5 5600 CL46 rating run at full speed on my Supermicro X14SAE without manual tuning?

The kit is spec-matched to the X14SAE memory controller, so the 5600 MT/s data rate and CL46 timing are recognised automatically at the rated 1.1 V.

Does the PC5-44800 label limit the bandwidth I can actually use?

PC5-44800 is the peak transfer rate for DDR5 5600; the motherboard's memory controller caps real-world throughput to that figure.

Do the 288-pin UDIMM modules fit the X14SAE DIMM slots without a heat spreader?

Yes, the 288-pin unbuffered UDIMM form factor matches the board's slots exactly, and the low-profile design without a heat spreader clears standard CPU coolers.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.