Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 16GB (2x8GB) DDR5 5600MHz CL46 1.1V UDIMM memory upgrade for Supermicro X14SAZ-TLN4F

SKU CH-4J0Y-2XEWY

A 16 GB dual-channel DDR5 kit running at 5600 MHz with CL46 latency and 1.1 V operation, matched to the Supermicro X14SAZ-TLN4F motherboard

  • Capacity16GB (2 x 8GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo
  • 16 GB dual-channel kit boosts multitasking headroom
  • DDR5 5600 MT/s speed matches board specification exactly
  • CL46 latency at 1.1 V runs within JEDEC baseline
  • Major OEM DRAM chips validated for stability at rated settings
  • 288-pin UDIMM form factor fits Supermicro X14SAZ-TLN4F slots

Exact-fit DDR5 upgrade for Supermicro

This 16 GB kit delivers two 8 GB UDIMMs rated at DDR5 5600 with CL46 timings and 1.1 V operation. It is built with major OEM DRAM chips and matches the rank, voltage and timing the motherboard expects. The modules install in the standard 288-pin slots without ECC or buffering.

Replaces slower or smaller DDR5 kits

If the system currently runs lower-frequency DDR5 or has fewer than 16 GB installed, this kit raises bandwidth and capacity in a single step. The jump is worth it when the workload benefits from the rated 5600 MT/s speed and the board’s qualified population rules are followed.

Sustained-load stability verified

Each module is tested at the rated speed, latency and voltage to ensure reliable operation during extended sessions. The unbuffered design and 1Rx8 organisation keep signal integrity consistent under continuous memory throughput.

Kohokohdat

  • 16 GB dual-channel kit boosts multitasking headroom
  • DDR5 5600 MT/s speed matches board specification exactly
  • CL46 latency at 1.1 V runs within JEDEC baseline
  • Major OEM DRAM chips validated for stability at rated settings
  • 288-pin UDIMM form factor fits Supermicro X14SAZ-TLN4F slots

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-818K2
Capacity16GB (2 x 8GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB 2X8GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will these 288-pin DDR5 UDIMM modules fit the Supermicro X14SAZ-TLN4F motherboard?

Yes, the kit is verified for that board and uses the exact 288-pin UDIMM form factor the motherboard requires, matching its memory-population rules.

What BIOS step is often missed when installing this DDR5 5600MHz CL46 kit?

After seating both 8 GB modules, enter the BIOS and confirm the memory runs at DDR5 5600 with CL46 at 1.1 V; some boards default to a slower speed until the profile is enabled.

Do the modules have a heat spreader that could need cleaning or replacement later?

No heat spreader is fitted, so there is no spreader to clean or replace; the bare modules only need occasional dust removal from the gold contacts.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.