NEMIX RAM 16GB DDR5 5600MHz CL46 ECC Registered RDIMM Supermicro H13SSL-NT memory upgrade

Supermicro H13SSL-NT DDR5 RDIMM Upgrade

This 16 GB DDR5 module is built for the Supermicro H13SSL-NT motherboard. It delivers registered ECC memory that the server platform requires for stable, error-corrected operation. The 1Rx8 organisation and 1.10 V voltage match the board's memory controller expectations exactly. Administrators expanding capacity in supported Supermicro servers will find the specifications aligned.

Installing the 288-Pin Registered Module

Installation follows the standard 288-pin RDIMM procedure for the target motherboard. The registered buffer reduces electrical load so all populated slots can run at the rated 5600 MT/s without signal degradation. The most common issue is ignoring the manual's population order; mixing ranks or skipping slots can prevent the system from recognising the full capacity. Consult the board documentation for the approved sequence before fitting the DIMM.

DDR5 5600 Registered ECC Limits

DDR5 at 5600 MT/s (PC5-44800) with CL46 latency provides the bandwidth and error correction the platform specifies. Registered ECC modules cannot be used in desktop boards that accept only unbuffered UDIMMs, and they will not fit SODIMM slots. The memory controller must support registered operation and the exact voltage; otherwise the module will not initialise. Buyers needing higher densities or different speeds must verify the motherboard's qualified vendor list.