Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Four green DDR5 RDIMM modules without heat spreaders in a kit

NEMIX RAM

NEMIX RAM 256GB 4x64GB DDR5 6400 CL52 2Rx4 1.1V ECC RDIMM Kit memory upgrade

SKU CH-D2HK-DKKRB

256 GB DDR5-6400 ECC registered kit with four 64 GB modules at CL52 and 1.1 V for the Supermicro H13DSH motherboard

  • Capacity256GB (4 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes
  • Exact-match 256GB kit runs at DDR5-6400 CL52 1.1V so the server recognises full capacity at rated speed
  • 2Rx4 Registered ECC RDIMM offloads the controller and corrects single-bit errors for enterprise stability
  • Verified fitment for Supermicro H13DSH motherboard with 288-pin RDIMM form factor and population rules
  • Major OEM Samsung Micron Hynix chips ensure consistent quality across all four 64GB modules
  • Lifetime replacement warranty with free US-based technical support included

Exact-match DDR5 server kit

This 256GB kit (4 x 64GB) delivers DDR5 6400 (PC5 51200) with CL52 latency at 1.10V. Registered ECC 2Rx4 RDIMM modules match the precise rank, voltage and timing the Supermicro H13DSH memory controller expects for full-capacity recognition and rated speed.

Registered architecture offloads the controller

Registered (buffered) design offloads the memory controller so every slot runs fully populated at full capacity while ECC catches and corrects single-bit errors on the fly. Low 1.10V operation and the absence of a heat spreader keep power draw and thermals modest in normal server workloads.

Requires DDR5 RDIMM slots and manual check

The 288-pin RDIMM form factor fits only DDR5 RDIMM slots — not UDIMM or SODIMM. Builders must consult the Supermicro H13DSH manual for supported capacities, approved DIMM population order and installation steps before purchase. No other motherboard or processor compatibility is implied.

Kohokohdat

  • Exact-match 256GB kit runs at DDR5-6400 CL52 1.1V so the server recognises full capacity at rated speed
  • 2Rx4 Registered ECC RDIMM offloads the controller and corrects single-bit errors for enterprise stability
  • Verified fitment for Supermicro H13DSH motherboard with 288-pin RDIMM form factor and population rules
  • Major OEM Samsung Micron Hynix chips ensure consistent quality across all four 64GB modules
  • Lifetime replacement warranty with free US-based technical support included

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-924K4
Capacity256GB (4 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 4X64GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Kysymyksiä tästä tuotteesta

How do I install the four 64GB DDR5 RDIMMs in the Supermicro H13DSH and which population order is the one people get wrong?

Install all four modules in the exact slot sequence shown in the H13DSH manual; the common mistake is skipping the prescribed population order, which prevents the board from recognising the full 256GB at DDR5-6400.

Will the Samsung Micron or Hynix chips on these ECC RDIMMs need any firmware updates or scheduled replacement?

No firmware updates or scheduled chip replacements are required; the on-die ECC and registered architecture handle error correction for the module's lifetime.

At what point does the 1.1V CL52 timing become the limiting factor during sustained server workloads?

The CL52 latency at 1.1V is the first timing ceiling you hit under continuous load; registered buffering keeps all four ranks stable at DDR5-6400 without further throttling.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.