NEMIX RAM DDR4 ECC RDIMM 256GB (8x32GB) 2133 CL15 1.2V 288-pin server RAM
- 256GB (8 x 32GB)
- 288-Pin DDR4 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
Eight unbuffered DDR4 ECC UDIMMs deliver 256 GB at 2666 MHz with CL19 latency and 1.2 V operation
Capacity 256GB (8 x 32GB)
This 256GB kit contains eight 32GB DDR4 2666 ECC UDIMM modules rated at PC4-21300 with CL19 latency. It runs at 1.2V on a 288-pin interface and uses 2Rx8 organisation with chips from major OEM suppliers. The kit targets servers and workstations that require error-correcting memory for data integrity.
The modules are unbuffered ECC UDIMMs, so they need a motherboard and CPU that explicitly support unbuffered ECC operation. Systems that require registered or load-reduced DIMMs cannot use this kit. Builders needing higher speeds, lower latency or non-ECC memory should look at other configurations.
Installation follows standard UDIMM procedure: power down, open the chassis, align the notch with the slot key and press until the latches click. Common issues arise when the platform does not support unbuffered ECC or when the BIOS is not configured to enable ECC, causing the system to ignore the modules or fail to boot.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR4 ECC Unbuffered UDIMM Memory |
| Part Number | ME21300-328K8 |
| Capacity | 256GB (8 x 32GB) |
| Type | 288-Pin DDR4 ECC UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Features | DDR4 ECC Unbuffered UDIMM Motherboard Compatible |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Yes — the kit uses 288-pin DDR4 ECC unbuffered UDIMM modules, so the board must provide DDR4 slots that accept ECC unbuffered memory.
If the board supports the combined capacity and rank count, mixing same-speed CL19 2Rx8 modules usually works; verify the motherboard’s maximum DIMM population and rank limits first.
Check the BIOS memory information or an OS tool such as dmidecode — it should report 2666 MT/s, CL19 timings, 1.20 V and ECC enabled for each 32 GB module.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?