Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Four green DDR4 UDIMM sticks, no heat spreaders, 288-pin, 32 GB kit

NEMIX RAM

NEMIX RAM 32GB (4×8GB) DDR4 3200 CL22 UDIMM memory upgrade

SKU CH-Z03Q-X3ZH7

A 32 GB kit of four 8 GB DDR4 3200 CL22 UDIMM modules for Supermicro desktop workstations

  • Capacity32GB (4 x 8GB)
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 32 GB kit expands desktop capacity
  • DDR4 3200 speed supports responsive multitasking
  • CL22 latency keeps timing tight
  • 20 V operation reduces power draw
  • Validated for Supermicro workstation compatibility

32 GB DDR4 kit for Supermicro workstations

This 32 GB kit contains four 8 GB DDR4 3200 UDIMM modules validated for Supermicro desktop workstations and the MBD-C9Z590-CGW board. Each stick runs at 1.2 V with CL22 latency and a 1Rx8 organisation. The unbuffered non-ECC design suits standard desktop memory slots without registered buffering.

1.2 V operation keeps thermals low

At the standard DDR4 voltage of 1.20 V the modules draw minimal power during typical desktop workloads. With no heat spreader fitted the bare PCB relies on case airflow, which is sufficient for ordinary office and workstation tasks. The low voltage also limits acoustic impact because no active cooling is required on the memory itself.

Sustained workloads stay stable

All modules are stress tested under load before shipping to verify reliability during extended compute sessions. The 288-pin UDIMM form factor fits the validated Supermicro platforms without signal integrity issues at 3200 MT/s. Builders needing ECC protection or registered DIMMs should select a different kit because this product is non-ECC and unbuffered.

Kohokohdat

  • 32 GB kit expands desktop capacity
  • DDR4 3200 speed supports responsive multitasking
  • CL22 latency keeps timing tight
  • 20 V operation reduces power draw
  • Validated for Supermicro workstation compatibility

Tekniset tiedot

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ Non-ECC Unbuffered UDIMM
Part NumberMD25600-818K4
Capacity32GB (4 x 8GB)
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 UDIMM
Rank1Rx8
FeaturesDDR4 Non- ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB (4X8GB) DDR4 3200MHZ PC4-25600 1Rx8 1.2V CL22 288-PIN Non-ECC Unbuffered UDIMM KIT

Kysymyksiä tästä tuotteesta

How do I install the 288-pin UDIMM modules in a Supermicro board, and what step is often missed?

Align the notch on each module with the slot key, press down firmly until both side clips click, then verify in BIOS that all 32GB are detected at 3200 MT/s.

What maintenance or replacement will this DDR4 kit need later?

No routine maintenance is required; if a module fails it is covered by a lifetime replacement warranty.

What limit appears first under sustained load with CL22 1.20V modules?

The CAS latency of 22 cycles sets the response-time floor before bandwidth or thermal limits become noticeable.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.