Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green bare circuit board DDR5 ECC UDIMM memory module

NEMIX RAM

NEMIX RAM 48GB DDR5 4800MHz ECC UDIMM 2Rx8 CL40 1.1V 288-Pin memory upgrade

SKU CH-WZ2A-E95ED

48 GB DDR5 ECC UDIMM running at 4800 MHz with CL40 latency and 1.1 V for Supermicro X14SAE motherboards

  • Capacity48GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 48GB

  • 48 GB DDR5 capacity runs demanding workloads without swapping
  • ECC protection corrects single-bit errors to prevent silent data corruption
  • DDR5 4800 speed with CL40 timing delivers rated bandwidth out of the box
  • 2Rx8 unbuffered UDIMM form factor matches the Supermicro X14SAE slot requirement
  • 1 V operation keeps power draw low for stable server uptime

Exact DDR5 ECC UDIMM for Supermicro X14SAE

This 48GB DDR5 4800MHz module is built as a direct memory upgrade for the Supermicro X14SAE motherboard. The unbuffered ECC UDIMM matches the board's 288-pin slot and memory population rules so the controller recognises the full capacity at rated speed. It targets administrators and workstation builders who need error-correcting memory without registered DIMM complexity.

Unbuffered 2Rx8 layout with major OEM chips

The stick uses Samsung Micron or Hynix components in a 2Rx8 organisation running at 1.1V CL40. No heat spreader is fitted so the low-profile PCB sits cleanly in dense server chassis where airflow is tight. The 288-pin gold edge connector aligns with the X14SAE DDR5 slots and the unbuffered design means no register delay for the memory controller.

Single-module kit simplifies population

The package contains one 48GB UDIMM so you can fill slots in the exact order the manual prescribes without splitting multi-stick kits. ECC circuitry detects and corrects single-bit errors on the fly protecting data integrity during long compute runs. Lifetime replacement coverage and US-based technical support back the module after installation.

Kohokohdat

  • 48 GB DDR5 capacity runs demanding workloads without swapping
  • ECC protection corrects single-bit errors to prevent silent data corruption
  • DDR5 4800 speed with CL40 timing delivers rated bandwidth out of the box
  • 2Rx8 unbuffered UDIMM form factor matches the Supermicro X14SAE slot requirement
  • 1 V operation keeps power draw low for stable server uptime

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME38400-4828K1
Capacity48GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the DDR5 4800 PC5-38400 interface limit the module to 4800 MT/s on the Supermicro X14SAE?

Yes, the module is rated at 4800 MT/s and the PC5-38400 designation confirms that peak transfer rate; the board will run it at that speed when populated correctly.

What physical slot and clearance does the 288-pin UDIMM need on the X14SAE?

It requires a standard 288-pin DDR5 UDIMM slot; the module has no heat spreader, so it fits under most CPU coolers, but verify the motherboard manual for DIMM population order.

How is the ECC UDIMM installed and what step is often missed?

Power off, open the retention clips, align the notch with the key, press firmly until both clips click, then confirm in BIOS that the full 48 GB is detected and ECC is enabled.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.