Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR5 5600MHz CL46 2Rx8 1.1V 288-pin UDIMM memory upgrade for Supermicro X14SAZ-TLN4F

SKU CH-R9BE-CXGVN

64GB dual-channel DDR5 kit with two 32GB UDIMMs running at 5600MHz CL46 1.1V for Supermicro X14SAZ-TLN4F

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo
  • 64 GB capacity from two 32 GB modules enables larger workloads
  • DDR5 5600 speed rated at PC5-44800 for faster data throughput
  • CL46 latency at 1.1 V matches the board's timing and voltage expectations
  • 2Rx8 dual-rank organisation uses major OEM Samsung, Micron or Hynix chips for tested stability
  • 288-pin UDIMM form factor fits the Supermicro X14SAZ-TLN4F motherboard exactly

Exact-match DDR5 kit for Supermicro X14SAZ-TLN4F

This 64GB kit contains two 32GB UDIMM modules rated at 5600MHz with CL46 latency and 1.10V operation. It uses 2Rx8 non-ECC unbuffered chips from major OEM suppliers and fits the 288-pin DDR5 slots on the specified motherboard. The modules are tested for stability at the rated speed and timing. No heat spreaders are included.

Replaces slower or smaller DDR5 memory on the same

The jump is worth it when your current modules run below 5600MHz or total capacity is under 64GB. Matching the board's exact rank, voltage, and timing requirements ensures full recognition and rated performance. Installing mismatched ranks or voltages can prevent boot or force lower speeds.

Sustained-load behaviour without heat spreaders

Under continuous workloads the bare chips rely on case airflow to stay within thermal limits. The 1.10V operating voltage helps moderate heat output during long sessions. Systems with restricted airflow may see throttling if ambient temperatures rise. Adequate chassis ventilation is required for consistent throughput.

Kohokohdat

  • 64 GB capacity from two 32 GB modules enables larger workloads
  • DDR5 5600 speed rated at PC5-44800 for faster data throughput
  • CL46 latency at 1.1 V matches the board's timing and voltage expectations
  • 2Rx8 dual-rank organisation uses major OEM Samsung, Micron or Hynix chips for tested stability
  • 288-pin UDIMM form factor fits the Supermicro X14SAZ-TLN4F motherboard exactly

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will the 288-pin DDR5 UDIMM modules fit the Supermicro X14SAZ-TLN4F motherboard slots?

Yes, the kit uses the standard 288-pin DDR5 UDIMM form factor that the X14SAZ-TLN4F requires; each module is a 32 GB 2Rx8 Non-ECC stick designed for the board's desktop memory slots.

What BIOS setting should I check after installing the 5600 MHz CL46 kit so it runs at the rated speed?

Enable the XMP or EXPO profile in the BIOS so the memory controller applies the 5600 MHz data rate, CL46 timings and 1.10 V automatically instead of falling back to a lower JEDEC speed.

Do these modules have a heat spreader that could need cleaning or replacement later?

No heat spreader is fitted; the bare DRAM chips rely on case airflow, so only occasional dust removal with compressed air is needed and no spreader maintenance is required.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.