Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green 204-pin DDR3 SODIMM module with black chips, no heat spreader

NEMIX RAM

NEMIX RAM 8GB DDR3 1333 PC3-10600 1.35V 204-Pin SODIMM POSIFLEX XT-5317 JIVA 17 memory upgrade

SKU CH-75C3-9H9NJ

8 GB DDR3 SODIMM running at 1333 MHz with 1.35 V for the POSIFLEX XT-5317 JIVA 17 terminal

  • Capacity8GB
  • SpeedDDR3 1333 (PC3 10600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.50V
  • 8 GB capacity expands terminal multitasking headroom
  • DDR3 1333 speed matches POSIFLEX XT-5317 JIVA 17 spec
  • 35 V low-voltage operation reduces power draw
  • 204-pin SODIMM form factor fits the terminal slot
  • Tested with Samsung, Micron or Hynix chips for stability

POS terminal memory upgrade

This 8GB DDR3 1333 SODIMM is built for the POSIFLEX XT-5317 JIVA 17 terminal. It uses a 204-pin unbuffered non-ECC layout at 1.35V to match the original specification. System integrators and IT teams can install it to restore or expand memory capacity in deployed point-of-sale units.

Sustained workload behaviour

Modules are stress tested under load before shipment to verify stability during continuous transaction processing. The CL9 latency and 2Rx8 organisation support steady throughput for database queries and peripheral I/O typical in retail environments. No heat spreader is fitted, so airflow in the terminal chassis manages thermals.

Pre-installation checklist

Confirm the terminal accepts a single 8GB 204-pin DDR3 SODIMM at 1.35V and that the memory slot is accessible for upgrade. Verify the existing configuration does not require ECC or registered modules. Check the service manual for any BIOS revision needed to recognise the full capacity.

Kohokohdat

  • 8 GB capacity expands terminal multitasking headroom
  • DDR3 1333 speed matches POSIFLEX XT-5317 JIVA 17 spec
  • 35 V low-voltage operation reduces power draw
  • 204-pin SODIMM form factor fits the terminal slot
  • Tested with Samsung, Micron or Hynix chips for stability

Tekniset tiedot

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR3 1333MHZ Non-ECC Unbuffered SODIMM
Part NumberMS10600-828K1
Capacity8GB
SpeedDDR3 1333 (PC3 10600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.50V
Compatible SystemPOSIFLEX POS
CAS LatencyCL9
Heat SpreaderNo
Type204-Pin DDR3 SODIMM
Rank2Rx8
FeaturesDDR3 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content8GB (1X8GB) DDR3 1333MHZ PC3-10600 2Rx8 1.35V 204-PIN Non-ECC Unbuffered SODIMM

Kysymyksiä tästä tuotteesta

How much heat or power draw should I expect from the 1.35V 8GB DDR3 1333 SODIMM when the POS terminal runs continuously?

The module operates at 1.35V with CL9 latency and no heat spreader, so it draws minimal power and runs cool during all-day use in the POSIFLEX XT-5317 JIVA 17 terminal.

What must the POSIFLEX XT-5317 JIVA 17 already have for this 204-pin DDR3 SODIMM to work?

The terminal needs a free 204-pin DDR3 SODIMM slot that accepts 1.35V non-ECC unbuffered memory at 1333MHz with 2Rx8 organisation.

Will this PC3-10600 8GB module work alongside the original memory already installed in the POSIFLEX XT-5317 JIVA 17?

Yes, it is built to match the system's DDR3 1333 specification, so it will run compatibly with existing modules at the same speed and voltage.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.