Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Six green DDR5 RDIMM modules in static bags

NEMIX RAM

NEMIX RAM DDR5 5600 ECC Registered RDIMM 288GB (6x48GB) CL46 1.1V Supermicro H13SSL-NT memory upgrade

SKU CH-ANWZ-10G35

A 288 GB DDR5 server kit with six 48 GB registered ECC modules rated at 5600 MHz, CL46 and 1.1 V, validated for the Supermicro H13SSL-NT motherboard

  • Capacity288GB (6 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 288GB 6X48GB

Näytä 24 muuta kokoonpanoa
  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 5600 speed with CL46 latency delivers rated throughput on the Supermicro H13SSL-NT
  • Registered ECC architecture offloads the memory controller and corrects single-bit errors
  • 1 V operation meets the board's voltage spec for stable full-population loads
  • 2Rx8 dual-rank organisation matches the motherboard's population rules for full recognition

Exact-match server upgrade

This 288GB kit contains six 48GB DDR5 RDIMMs built for the Supermicro H13SSL-NT motherboard. Each module runs at 5600 speed with CL46 timing at 1.1V. The registered ECC design matches the board's required rank and voltage so the system recognises full capacity immediately.

DDR5 bandwidth and latency

The PC5-44800 standard delivers 5600 MT/s transfer rates with a fixed CAS latency of 46 cycles. Registered buffering adds one cycle of command delay but allows all slots to operate at full speed. ECC correction handles single-bit errors without software intervention.

Enterprise build for dense population

Major OEM Samsung, Micron or Hynix chips sit on bare green PCBs without heat spreaders, keeping module height low for tight server chassis. The 288-pin RDIMM keying prevents mis-installation in UDIMM or SODIMM slots. Six modules fill the board's validated population sequence for maximum density.

Kohokohdat

  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 5600 speed with CL46 latency delivers rated throughput on the Supermicro H13SSL-NT
  • Registered ECC architecture offloads the memory controller and corrects single-bit errors
  • 1 V operation meets the board's voltage spec for stable full-population loads
  • 2Rx8 dual-rank organisation matches the motherboard's population rules for full recognition

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-4828K6
Capacity288GB (6 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content288GB 6X48GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Should I pick the 6 x 48 GB kit or a different capacity for my Supermicro H13SSL-NT?

The kit provides exactly 288 GB as six 48 GB modules, matching the board's DDR5 RDIMM slot count and population rules for full-capacity operation.

What does DDR5-5600 (PC5-44800) actually deliver once installed in the server?

The modules run at 5600 MT/s with CL46 latency at 1.1 V, giving the memory controller the exact timing and voltage it expects for stable, rated-speed performance.

How does the 288-pin RDIMM interface and registered ECC design affect my system?

The registered buffer reduces electrical load on the controller so all slots can run fully populated, while ECC corrects single-bit errors on the fly to prevent silent data corruption.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.