Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Transparent frameless DC fan with two wires and a 2 pin connector

OEM Industries

OEM Industries A6010C12C Frameless DC Cooler 12V .30A 2 Pin Transparent

SKU CH-XSGJ-0T2KD

Frameless 12 V DC fan with ceramic bearing and two-pin power for Sapphire X1300XT and X1600PRO video cards

  • ColorTransparent
  • TypeFan only
  • Bearing TypeARCTIC Ceramic
  • Power Connector2 Pin
  • LEDNo
  • Frameless design fits tight spaces around video cards
  • 12 V .30 A draws minimal power from the board
  • Two-pin connector enables simple plug-in installation
  • ARCTIC ceramic bearing reduces friction for longer life
  • Compatible with Sapphire X1300XT and X1600PRO models

Frameless 12V DC Cooler for Legacy Graphics

This frameless DC cooler operates at 12V and draws 0.30A through a two-pin connector. It is supplied as a fan-only unit with a transparent finish and ARCTIC ceramic bearing. The cooler is intended for older Sapphire video cards including the X1300XT and X1600PRO models.

Two-Pin 12V Power Connector

The single specification that determines fit is the two-pin 12V power connector rated at 0.30A. This connector must match the header on the target graphics card exactly; no adapter or voltage conversion is mentioned. Verify the card's original cooler uses the same two-wire interface before ordering.

Direct Replacement Installation

Installation consists of removing the original cooler and mounting this unit using the existing screw holes on the supported Sapphire cards. The frameless design leaves no shroud to align, but the bare frame requires careful handling to avoid bending blades. The most common issue is a mismatched pin header or insufficient wire reach on non-listed models.

Kohokohdat

  • Frameless design fits tight spaces around video cards
  • 12 V .30 A draws minimal power from the board
  • Two-pin connector enables simple plug-in installation
  • ARCTIC ceramic bearing reduces friction for longer life
  • Compatible with Sapphire X1300XT and X1600PRO models

Tekniset tiedot

ModelA6010C12C
ColorTransparent
TypeFan only
Bearing TypeARCTIC Ceramic
Power Connector2 Pin
LEDNo

Kysymyksiä tästä tuotteesta

How much current does the 12 V frameless cooler draw in a real build?

The cooler is rated at 0.30 A on a 12 V supply, so it will pull roughly that amount when running in your system.

What does the 2-pin connector limit compared with a 3- or 4-pin header?

A 2-pin connector supplies power only, so the fan runs at a fixed speed and cannot report RPM or accept PWM control from the motherboard.

Will the frameless design fit the mounting holes on a Sapphire X1300XT or X1600PRO?

The product is listed specifically for those Sapphire cards, indicating the cooler's mounting pattern matches the original video-card cooler brackets.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.