OEM Industries
OEM Industries MMF-08C24ES RM1 80mm 24V 3 Pin Fan
80 mm square fan with 2-ball bearings runs on 24 V at 0.16 A for YASKAWA or ABB inverter cooling
- ColorBlack
- TypeFan only
- Fan Size80mm
- Bearing Type2 Ball
- Power Connector3 Pin
- 80 mm square frame fits tight spaces
- 24 V 0.16 A rating matches industrial inverters
- 3-pin connector enables speed monitoring
- 2-ball bearing design extends service life
- Original Melco build for Yaskawa PLC ABB compatibility
Compact 80 mm frame for industrial cooling
The Melco MMF-08C24ES RM1 is an 80 by 25 mm square fan designed for 24 V DC systems. It uses a two-ball bearing and a three-pin connector drawing zero point one six amps. The unit targets engineers maintaining YASKAWA or ABB inverter enclosures where original-equipment airflow must be preserved.
Direct replacement for worn Melco units
This fan matches the CA1321-H01 form factor and pin-out, so it drops into existing inverter chassis without rewiring. The jump is worth it when the original bearing noise rises or airflow drops below spec, restoring the cooling curve the drive electronics expect.
Fits tight inverter bays with three-wire monitoring
The 80 mm footprint slides into standard PLC cut-outs, while the third wire feeds speed feedback to the drive controller. Two-ball construction tolerates continuous duty and vibration better than sleeve alternatives, freeing maintenance windows for other tasks.
Kohokohdat
- 80 mm square frame fits tight spaces
- 24 V 0.16 A rating matches industrial inverters
- 3-pin connector enables speed monitoring
- 2-ball bearing design extends service life
- Original Melco build for Yaskawa PLC ABB compatibility
Tekniset tiedot
| Model | MMF-08C24ES RM1 |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 80mm |
| Bearing Type | 2 Ball |
| Power Connector | 3 Pin |
Kysymyksiä tästä tuotteesta
What mounting hole spacing does the 80mm square frame use?
The fan has an 80mm square frame with a 25mm thickness; standard 80mm mounting holes apply.
How do I connect the 3 pin connector to a 24V source?
Match the three wires to the 24V supply pins; the third wire carries the tachometer signal.
When should the 2 ball bearing be replaced?
Replace the fan if bearing noise increases or airflow drops below the original 3W operating level.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 $
0.00001051BTC
Varastossa