Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two red LED 120mm case fans with anti-vibration rubber pads and Molex 4-pin connectors

sakose

sakose 12025-LED 120mm case fan 15 LED red 1100 RPM 18 dBA 2 pack

SKU CH-R8JW-QZE95 MPN 12025-LED

Two 120 mm case fans with 15 red LEDs each, running at 1100 RPM and 18 dBA

  • ColorRed
  • LEDRed

Color Red

LED Red

Option 2 Fans, No Controller

  • Two fans included for balanced intake and exhaust
  • 120 mm hydraulic bearing runs at 1100 RPM with 18 dBA noise
  • Fifteen red LEDs create vivid lighting effects
  • Anti-vibration rubber pads reduce chassis resonance
  • Molex 4-pin connector supplies 12 VDC power

Two-Pack 120mm LED Case Fans

This twin set of 120mm case fans targets builders who want a matching pair of red LED fans for a standard chassis. Each unit draws 12 VDC through a Molex four-pin connector and ships with anti-vibration rubber pads.

Hydraulic Bearing at 1100 RPM

The hydraulic bearing spins at 1100 RPM with a rated noise level of 18 dBA, keeping acoustic output low during extended sessions. Nine curved blades and a cut-back frame are designed to sustain airflow and pressure without the turbulence spike that short bursts can hide.

Molex Power and Rubber Mounts

Installation uses the Molex four-pin plug and the included rubber pads, which fit the standard 120mm mounting holes found on most cases and radiators. The only common issue is cable routing when the Molex lead is shorter than the distance to the power supply.

Kohokohdat

  • Two fans included for balanced intake and exhaust
  • 120 mm hydraulic bearing runs at 1100 RPM with 18 dBA noise
  • Fifteen red LEDs create vivid lighting effects
  • Anti-vibration rubber pads reduce chassis resonance
  • Molex 4-pin connector supplies 12 VDC power

Tekniset tiedot

BrandSakose
ColorRed
LEDRed

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How loud are the 18 dBA fans when they run continuously at 1100 RPM?

The fans are rated at 18 dBA with a tolerance of ten percent, so they remain very quiet even during all-day operation at 1100 RPM.

Do I need a Molex 4-pin connector from my power supply for these two fans?

Yes, each fan draws power through a standard Molex 4-pin connector, so your power supply must provide two free Molex leads.

Will the 120 mm frame and anti-vibration pads fit the same mounting holes as my older 120 mm case fans?

The 120 mm frame matches the standard mounting pattern and the included anti-vibration rubber pads use the same screw holes, so they drop into existing 120 mm locations.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.