Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Silver 3.5 inch enterprise hard drive bare unit with label

Seagate

Seagate Constellation ES.3 ST3000NM0033 3TB 7200 RPM 128MB SATA 6.0Gb/s 3.5" internal hard drive

SKU CH-QSFP-JC0Y7 MPN ST3000NM0033

Enterprise 3.5" SATA drive stores 3 TB at 7200 RPM with 128 MB cache for 24×7 bulk data workloads

  • PackagingBare Drive
  • InterfaceSATA 6.0Gb/s
  • Capacity3TB
  • RPM7200 RPM
  • Cache128MB
  • Average Latency4.16ms

Options 3TB

  • 3 TB capacity stores bulk enterprise data
  • 7200 RPM and 128 MB cache deliver sustained throughput
  • SATA 6.0 Gb/s interface fits standard servers
  • DoD 5220.22 M erase ensures clean deployment
  • 24×7 rated design supports continuous operation

Capacity and Purpose

The Seagate Constellation ES.3 ST3000NM0033 is a 3TB 3.5 inch enterprise hard drive built for 24×7 bulk-data storage. It connects via a SATA 6.0Gb/s interface and spins at 7200 RPM with a 128MB cache. The drive suits servers and storage arrays that need high-capacity, always-on operation rather than peak single-user speed.

Sustained Load Behaviour

With an average latency of 4.16ms, the drive delivers consistent throughput for sequential workloads such as backups, archives and video surveillance recording. Enterprise firmware prioritises steady performance over burst speed, and the 7200 RPM spindle maintains stable transfer rates during long write sessions. Best-in-class energy efficiency helps keep operating costs down in multi-drive enclosures.

Installation Notes

The bare drive measures 147.00mm long, 101.85mm wide and 26.10mm high, fitting standard 3.5 inch drive bays and hot-swap trays. No mounting rails or cables are included. Units are erased to DoD 5220.22-M standard and tested good; up to 25 bad sectors may be present and cosmetic markings can vary. The drive arrives unformatted and unpartitioned, so the installer must initialise it in the host system.

Kohokohdat

  • 3 TB capacity stores bulk enterprise data
  • 7200 RPM and 128 MB cache deliver sustained throughput
  • SATA 6.0 Gb/s interface fits standard servers
  • DoD 5220.22 M erase ensures clean deployment
  • 24×7 rated design supports continuous operation

Tekniset tiedot

BrandSeagate
SeriesConstellation ES.3
ModelST3000NM0033
PackagingBare Drive
InterfaceSATA 6.0Gb/s
Capacity3TB
RPM7200 RPM
Cache128MB
Average Latency4.16ms
FeaturesCapacity-Optimized Enterprise Hard Drive for Bulk-Data Applications
- Highest-capacity large form factor enterprise drive - up to 4TB - for demanding data growth
- Sixth-generation drive technology with SAS and SATA interfaces for 24x7 reliability
- Enhanced error correction, super parity and end-to-end SAS-based data integrity for accurate data storage
- Best-in-class rotational vibration tolerance ensures consistent performance.
- Improved power and cooling efficiencies with low power consumption and on-demand PowerChoice technology based on T10/T13 power management standards
- Mul
UsageFor Enterprise Storage
Form Factor3.5"
Height (maximum)26.10mm
Width (maximum)101.85mm
Length (maximum)147.00mm
Lähetyspaino0.72 kg
Pakkauksen mitat146 × 102 × 25 mm

Tämän mallin muut versiot

3 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How much power does the ST3000NM0033 draw during 24×7 operation?

The drive is described as best-in-class for energy efficiency, built for reliable 24×7 bulk data storage with a 7200 RPM spindle and 128MB cache.

Does the SATA 6.0Gb/s interface need a specific controller or backplane to work?

It connects to any standard SATA 6.0Gb/s port on a motherboard, RAID card or hot-swap backplane; the 3.5-inch form factor fits normal drive bays.

Will this 3TB enterprise drive work in a desktop that currently runs older 7200 RPM SATA drives?

Yes, it uses the same SATA interface and 3.5-inch dimensions, so it installs alongside existing drives and is recognised by the BIOS or OS without extra steps.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.