Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Rectangular silver server PSU, two fans, 20-pin connector, 3.9 by 1.6 by 8.0 inches

Sparkle Power Inc.

Sparkle Power Inc. FSP300-601U 300W server power supply

SKU CH-MKVZ-WKPF8 MPN FSP300-601U

Delivers 300W through a 20-pin ATX connector with dual fans and active PFC for server builds

  • TypeComplied with ATX and ATX12Vstandard
  • Single/RedundantSingle
  • Maximum Power300W
  • Main Connector20Pin
  • Output+3.3V@20A; +5V@25A; +12V@16A; [email protected] ; [email pro
  • Input Voltage90 - 264 V
  • 300 W maximum power for server workloads
  • 100,000 hour MTBF at 25 °C full load
  • Active PFC meets EN61000-3-2 for clean input current
  • Dual fans with thermal speed control for quiet cooling
  • Wide 90–264 V input suits global rack deployments

Server PSU for legacy 20-pin builds

The Sparkle FSP300-601U is a 300W single power supply built to the ATX and ATX12V standard. It uses a 20-pin main connector and delivers +3.3V at 20A, +5V at 25A and +12V at 16A. The unit accepts 90-264V input at 47-63Hz for worldwide rack deployment.

Sustained load behaviour with dual fans

Two internal fans run under thermal speed control to keep noise low while the supply operates at full load up to 40°C. Efficiency is rated at 68% under maximum output with active power factor correction meeting EN61000-3-2. MTBF reaches 100000 hours at 25°C and hold-up time is 17ms minimum.

Replaces older 20-pin ATX units

This supply fits servers and workstations that still require a 20-pin main connector rather than the newer 24-pin design. The jump is worth it when the original unit has failed or when ripple and noise have risen beyond spec. It does not suit builds needing redundant power or 24-pin motherboards.

Kohokohdat

  • 300 W maximum power for server workloads
  • 100,000 hour MTBF at 25 °C full load
  • Active PFC meets EN61000-3-2 for clean input current
  • Dual fans with thermal speed control for quiet cooling
  • Wide 90–264 V input suits global rack deployments

Tekniset tiedot

BrandSPARKLE
ModelFSP300-601U
TypeComplied with ATX and ATX12Vstandard
Single/RedundantSingle
Maximum Power300W
Main Connector20Pin
Output+3.3V@20A; +5V@25A; +12V@16A; [email protected] ; [email protected] ; +5SB@2A
Input Voltage90 - 264 V
Input Frequency Range47 - 63 Hz
Input Current6A @ 115V, 3A @ 230V
Fans2
MTBF100,000 hours on maximum load at +25° C degree
Efficiency68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
Hold-up Time17ms min.
FeaturesActive Power Factor Correction Meeting with EN61000-3-2
High efficiency and reliability
Remote On/Off function
Internal 12V DC fan included
Noise Killer (Thermal fan speed control function)
Low noise and ripple
Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
Output over voltage, short circuit, and over current protection
100% Hi-pot, ATE, and burn-in tested
Re-settable power shut down
Approved by UL 60950, CSA C22.2 Level 3, TUV EN60950, NEMKO EN60950 (CB Report), CE
Dimensions3.9" x 1.6" x 8.0"
Humidity5~95% on operating and storage
Temperature0° C ~ 40° C on full load
Lähetyspaino1.52 kg
Pakkauksen mitat203 × 102 × 51 mm

Kysymyksiä tästä tuotteesta

How loud is the dual-fan cooling at full 300 W load?

Two internal 12 V DC fans run under thermal speed control; the Noise Killer function slows them when temperatures allow, keeping acoustic output low during continuous operation.

Which motherboard power connector does the 20-pin main lead fit?

The supply terminates in a 20-pin ATX main connector, so the host board must provide a matching 20-pin socket or a 24-pin socket that accepts the 20-pin plug.

Will the 90–264 V auto-range input work with my existing 230 V rack PDU?

Yes — the unit accepts 90 to 264 V at 47–63 Hz and draws 3 A at 230 V, so it connects directly to standard 230 V rack power distribution without a selector switch.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.