Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Black 135mm square case fan with dual ball bearing and two wires

SXDOOL

SXDOOL 135mm Case Fan 1800 RPM Dual Ball Bearing 2 Pin

SKU CH-E059-9R93X

135 mm case fan spins up to 1800 RPM with dual ball bearings and a two-pin connector for 12 V power

  • TypeCase Fan
  • Fan Size135mm
  • Bearing Type2 Ball
  • RPM1600-1999 RPM
  • Noise Level25 - 30 dBA
  • Power Connector2 Pin
  • 135 mm frame fits PSU and chassis mounts with 120 mm hole spacing
  • Dual ball bearing design extends operating life at 1800 RPM
  • 29 dBA noise level keeps system acoustics low under load
  • 28 A draw on 12 V rail limits power budget impact
  • Two-pin connector enables direct PSU or motherboard header power

135mm dual-ball-bearing case fan

The SXDOOL DFB13512H is a 135mm square chassis fan built around a dual ball bearing for longer service life. It runs on 12 V DC, draws 0.28 A and spins at 1800 RPM with a 10 % tolerance. The two-wire connector supplies power without speed reporting or PWM control.

Two-wire power connector

The red and black lead pair delivers simple voltage control through any 2-pin header or adapter. No tachometer signal or PWM input is present, so fan speed cannot be monitored or regulated by the motherboard. Builders who want software-controlled curves or RPM feedback need a three- or four-wire alternative.

120mm mounting holes and 29 dBA noise

Mounting holes are spaced at 120 mm, matching many 120mm fan patterns and some PSU shrouds. At 29 dBA the airflow is audible but not intrusive in a typical case. The 25 mm thickness and 135 mm frame limit use to locations that accept this specific footprint.

Kohokohdat

  • 135 mm frame fits PSU and chassis mounts with 120 mm hole spacing
  • Dual ball bearing design extends operating life at 1800 RPM
  • 29 dBA noise level keeps system acoustics low under load
  • 28 A draw on 12 V rail limits power budget impact
  • Two-pin connector enables direct PSU or motherboard header power

Tekniset tiedot

TypeCase Fan
Fan Size135mm
Bearing Type2 Ball
RPM1600-1999 RPM
Noise Level25 - 30 dBA
Power Connector2 Pin
ColorBlack
LEDNon-LED

Kysymyksiä tästä tuotteesta

How long do the dual ball bearings last before they need replacement?

Dual ball bearings typically outlast sleeve bearings and can run for years at 1800 RPM without scheduled replacement.

What limits continuous operation at 1800 RPM?

The 0.28 A current draw and 29 dBA noise level are the main constraints during sustained use.

How much heat and noise does the fan produce when running all day?

It runs at 1800 RPM, draws 0.28 A at 12 V and emits 29 dBA, so heat output is low and noise stays moderate.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.