Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

Syba

Syba SY-CAB40007 5.5" 4-Pin Molex to 2x SATA Power Cable

SKU CH-38N8-ZY9H6 MPN SY-CAB40007

A 5.5 inch Molex to dual SATA power cable connects two drives from one 4-pin connector

  • Weight0.1
  • Connect two SATA drives from one Molex connector
  • 5 inch length fits tight drive bays
  • Three connectors: one Molex male and two SATA
  • Lightweight 0.1 lb design adds minimal cable bulk

Power Splitter for SATA Drives

This 5.5-inch adapter converts a single 4-pin Molex connector into two 15-pin SATA power plugs. It lets builders add a pair of hard drives or solid-state drives without needing extra leads from the power supply. The short length keeps cable routing tidy inside compact cases.

Sustained Load Behaviour

The cable uses standard gauge wiring rated for continuous current draw from two spinning disks. Voltage drop stays minimal across the 5.5-inch run, so drives receive stable power during long write sessions or RAID rebuilds. No active cooling or thermal throttling applies to this passive assembly.

Kohokohdat

  • Connect two SATA drives from one Molex connector
  • 5 inch length fits tight drive bays
  • Three connectors: one Molex male and two SATA
  • Lightweight 0.1 lb design adds minimal cable bulk

Tekniset tiedot

BrandIO Crest
ModelSY-CAB40007
Weight0.1
Lähetyspaino0.02 kg
Pakkauksen mitat110 × 76 × 23 mm

Kysymyksiä tästä tuotteesta

Does the 5.5 inch cable add noticeable heat or electrical noise when powering two SATA drives all day?

The short 5.5 inch cable carries only power from the 4-pin Molex connector to two 15-pin SATA drives, adding no active components that generate heat or noise.

What existing power connector must my power supply provide for this cable to work?

Your power supply needs a free 4-pin Molex connector to plug the male end of this adapter into.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.