A-Tech 16GB DDR4 3200 ECC RDIMM 1Rx8 CL22 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
A 32 GB dual-channel kit of DDR4 2933 ECC registered DIMMs for servers and workstations
Capacity 32GB (2 x 16GB)
This A-Tech kit provides 32GB of DDR4 ECC registered memory across two 16GB modules. It is built for servers and workstations that require error correction and registered signalling. Desktop and laptop systems cannot use these modules.
Each module runs at the standard 1.2V DDR4 voltage without a heat spreader. The single-rank 1Rx8 organisation helps keep power draw modest under typical server workloads. No active cooling is included or required by the modules themselves.
The 288-pin DIMMs install in dual-channel pairs following the system manual’s seating guidelines. Registered buffering and ECC function only on platforms designed for DDR4 RDIMM memory. Buyers who need non-ECC or unbuffered modules for consumer boards cannot use this kit.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR4 Server Memory RAM |
| Model | A-Tech 16GB 1Rx8 PC4-2933Y-R |
| Part Number | AT16G2D4D2933RS8N12V |
| Capacity | 32GB (2 x 16GB) |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Multi-channel Kit | Dual Channel Kit |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Features | Major Brand Chips / Error Correcting Technology for Server Systems |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Power off the server, open the chassis, align each module's notch with the slot key, press down until the retention clips click, then verify in BIOS that both 16GB modules are detected at 2933 MHz.
No scheduled maintenance is required; the modules have no heat spreaders or moving parts, so replacement is only necessary if a module fails or the server's maximum supported capacity is increased.
The DDR4 2933 MT/s data rate and CL21 latency set the throughput ceiling; sustained workloads will hit that bandwidth limit before the 1.20V voltage or single-rank architecture becomes a constraint.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?