NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
A-Tech
8GB DDR3 1600MHz ECC registered DIMM, dual-rank Samsung chips, Supermicro certified
This 8GB registered DIMM uses Samsung chips and runs at DDR3 1600MHz with CL11 latency. It is certified for Supermicro systems and carries the MEM-DR380L-SL01-ER16 part number. The module is built for servers and workstations that require error-correcting registered memory.
Operating at the standard 1.5V DDR3 voltage, the module draws typical power for an 8GB registered stick. Passive cooling through the server chassis airflow keeps temperatures within normal limits. No active cooling or additional fan noise is introduced by the memory itself.
The dual-rank 2Rx4 organisation helps maintain bandwidth during extended workloads. ECC registration adds a clock cycle of buffering, which stabilises the signal under continuous read and write cycles. The module is tested for reliable operation in 24/7 server environments.
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR380L-SL01-ER16 |
| Capacity | 8GB |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Samsung Chipset |
| Features | Supermicro Certified MEM-DR380L-SL01-ER16 (M393B1K70DH0-CK0) |
Power down the server, open the chassis, align the module key notch with the slot, press firmly until both retention clips click, then verify the system BIOS reports the full 8 GB at 1600 MHz; the step often missed is enabling ECC in the BIOS after the physical install.
No scheduled maintenance is required; the module is tested for lifetime reliability, so replacement is only needed if a memory diagnostic reports uncorrectable ECC errors or the server fails to POST with the DIMM seated.
The thermal and voltage envelope of DDR3 at 1.50 V and CL11 latency defines the sustained performance ceiling; the registered buffer adds minor latency but prevents signal degradation, so the memory controller’s maximum supported bandwidth at 1600 MHz is the limiting factor.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?