NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
8GB DDR3 1600MHz ECC registered DIMM, dual-rank Samsung chips, Supermicro certified
This 8GB registered DIMM uses Samsung chips and runs at DDR3 1600MHz with CL11 latency. It is certified for Supermicro systems and carries the MEM-DR380L-SL01-ER16 part number. The module is built for servers and workstations that require error-correcting registered memory.
Operating at the standard 1.5V DDR3 voltage, the module draws typical power for an 8GB registered stick. Passive cooling through the server chassis airflow keeps temperatures within normal limits. No active cooling or additional fan noise is introduced by the memory itself.
The dual-rank 2Rx4 organisation helps maintain bandwidth during extended workloads. ECC registration adds a clock cycle of buffering, which stabilises the signal under continuous read and write cycles. The module is tested for reliable operation in 24/7 server environments.
| Brand | SuperMicro |
|---|---|
| Series | Supermicro Certified |
| Model | MEM-DR380L-SL01-ER16 |
| Capacity | 8GB |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Samsung Chipset |
| Features | Supermicro Certified MEM-DR380L-SL01-ER16 (M393B1K70DH0-CK0) |
Power down the server, open the chassis, align the module key notch with the slot, press firmly until both retention clips click, then verify the system BIOS reports the full 8 GB at 1600 MHz; the step often missed is enabling ECC in the BIOS after the physical install.
No scheduled maintenance is required; the module is tested for lifetime reliability, so replacement is only needed if a memory diagnostic reports uncorrectable ECC errors or the server fails to POST with the DIMM seated.
The thermal and voltage envelope of DDR3 at 1.50 V and CL11 latency defines the sustained performance ceiling; the registered buffer adds minor latency but prevents signal degradation, so the memory controller’s maximum supported bandwidth at 1600 MHz is the limiting factor.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?