Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
KHACHIMO 250W ATX power supply with 20 pin connector and eight SATA plugs

KHACHIMO

KHACHIMO DVR NVR 20Pin SATA*8 250W Switching Power Supply

SKU CH-WDAE-ATZ8P

ATX power supply with a 20-pin connector and eight SATA outputs delivering 250 W

  • TypeATX
  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

DVR NVR power supply with 20-pin connector

The KHACHIMO PSF-250M4 is a 250W ATX switching unit built for DVR and NVR recorders. It delivers eight SATA power connectors to run multiple surveillance drives from a single source. The supply is tested working before dispatch and aimed at installers who need a direct replacement for recorders using a 20-pin main plug.

Thermals noise and 250W power draw

A standard ATX cooling fan moves air through the chassis during normal recording loads. Acoustic output stays at a typical office background level when the system is idle or writing video streams. The 250W rating sets the maximum continuous draw the unit is designed to supply across all rails.

Istaknuto

  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

Specifikacije

TypeATX

Pitanja o ovom artiklu

How do I connect the 20-pin ATX connector and all eight SATA cables without overloading the 250W supply?

Plug the 20-pin ATX block into the motherboard, then attach each SATA drive to its own cable; keep total draw under 250W by avoiding high-power GPUs or extra adapters on the same unit.

When should I replace the internal fan or the electrolytic capacitors in this 250W switching supply?

Replace the fan if it becomes noisy or stops spinning; plan capacitor replacement after roughly five years of continuous DVR or NVR operation to prevent voltage drift.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.