Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
KHACHIMO 250W ATX power supply with 20 pin connector and eight SATA plugs

KHACHIMO

KHACHIMO DVR NVR 20Pin SATA*8 250W Switching Power Supply

SKU CH-WDAE-ATZ8P

ATX power supply with a 20-pin connector and eight SATA outputs delivering 250 W

  • TypeATX
  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

DVR NVR power supply with 20-pin connector

The KHACHIMO PSF-250M4 is a 250W ATX switching unit built for DVR and NVR recorders. It delivers eight SATA power connectors to run multiple surveillance drives from a single source. The supply is tested working before dispatch and aimed at installers who need a direct replacement for recorders using a 20-pin main plug.

Thermals noise and 250W power draw

A standard ATX cooling fan moves air through the chassis during normal recording loads. Acoustic output stays at a typical office background level when the system is idle or writing video streams. The 250W rating sets the maximum continuous draw the unit is designed to supply across all rails.

Poudarki

  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

Specifikacije

TypeATX

Vprašanja o tem izdelku

How do I connect the 20-pin ATX connector and all eight SATA cables without overloading the 250W supply?

Plug the 20-pin ATX block into the motherboard, then attach each SATA drive to its own cable; keep total draw under 250W by avoiding high-power GPUs or extra adapters on the same unit.

When should I replace the internal fan or the electrolytic capacitors in this 250W switching supply?

Replace the fan if it becomes noisy or stops spinning; plan capacitor replacement after roughly five years of continuous DVR or NVR operation to prevent voltage drift.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.