Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.

Overvåkingsliste Logg inn
KHACHIMO 250W ATX power supply with 20 pin connector and eight SATA plugs

KHACHIMO

KHACHIMO DVR NVR 20Pin SATA*8 250W Switching Power Supply

SKU CH-WDAE-ATZ8P

ATX power supply with a 20-pin connector and eight SATA outputs delivering 250 W

  • TypeATX
  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

DVR NVR power supply with 20-pin connector

The KHACHIMO PSF-250M4 is a 250W ATX switching unit built for DVR and NVR recorders. It delivers eight SATA power connectors to run multiple surveillance drives from a single source. The supply is tested working before dispatch and aimed at installers who need a direct replacement for recorders using a 20-pin main plug.

Thermals noise and 250W power draw

A standard ATX cooling fan moves air through the chassis during normal recording loads. Acoustic output stays at a typical office background level when the system is idle or writing video streams. The 250W rating sets the maximum continuous draw the unit is designed to supply across all rails.

Høydepunkter

  • 250 W output powers demanding DVR or NVR systems
  • 20-pin main connector fits compatible recorder motherboards
  • Eight SATA connectors supply multiple hard drives simultaneously
  • Tested working unit confirms reliable operation out of the box

Spesifikasjoner

TypeATX

Spørsmål om denne varen

How do I connect the 20-pin ATX connector and all eight SATA cables without overloading the 250W supply?

Plug the 20-pin ATX block into the motherboard, then attach each SATA drive to its own cable; keep total draw under 250W by avoiding high-power GPUs or extra adapters on the same unit.

When should I replace the internal fan or the electrolytic capacitors in this 250W switching supply?

Replace the fan if it becomes noisy or stops spinning; plan capacitor replacement after roughly five years of continuous DVR or NVR operation to prevent voltage drift.

Også i denne avdelingen

Kunder sammenlignet disse

Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.