NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
Kingston Technology Corp.
Registered ECC DDR4 module with CL17 timing and 2400 MHz speed for server stability
This 8 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.20 V operation. It uses a registered design with parity ECC for error detection. The 288-pin DIMM fits standard desktop slots that support registered memory. It is built with Hynix D-Die for consistent stability.
Registered DIMMs include an on-module register that adds a small, constant power overhead compared with unbuffered sticks. The 1.20 V rating keeps heat output low during typical workloads. No active cooling is required on the module itself. System airflow normally handles the modest thermal load.
Parity ECC lets the memory controller detect single-bit errors before they corrupt data. The registered buffer reduces electrical load on the memory bus, which helps signal integrity when multiple modules are populated. These features target servers and workstations that prioritise uptime over raw latency. Builders who need unbuffered non-ECC memory for consumer platforms should choose a different module type.
| Brand | Kingston |
|---|---|
| Model | KSM24RS8/8HDI |
| Capacity | 8GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Parity |
| Buffered/Registered | Registered |
Align the notch with the motherboard slot key, press firmly until both retention clips click, then verify the BIOS recognises the module as registered ECC at 1.20 V; the step most often missed is enabling ECC in the firmware before first boot.
No scheduled maintenance is required; keep the contacts free of dust with compressed air and replace the module only if memory diagnostics report correctable or uncorrectable ECC errors.
The CAS latency of CL17 at 2400 MHz sets the timing ceiling; sustained throughput is bounded by the 19200 MB/s PC4-19200 rating and the registered buffer adds one cycle of command delay.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?