NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.
Kingston Technology Corp.
Registered ECC DDR4 module with CL17 timing and 2400 MHz speed for server stability
This 8 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.20 V operation. It uses a registered design with parity ECC for error detection. The 288-pin DIMM fits standard desktop slots that support registered memory. It is built with Hynix D-Die for consistent stability.
Registered DIMMs include an on-module register that adds a small, constant power overhead compared with unbuffered sticks. The 1.20 V rating keeps heat output low during typical workloads. No active cooling is required on the module itself. System airflow normally handles the modest thermal load.
Parity ECC lets the memory controller detect single-bit errors before they corrupt data. The registered buffer reduces electrical load on the memory bus, which helps signal integrity when multiple modules are populated. These features target servers and workstations that prioritise uptime over raw latency. Builders who need unbuffered non-ECC memory for consumer platforms should choose a different module type.
| Brand | Kingston |
|---|---|
| Model | KSM24RS8/8HDI |
| Capacity | 8GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Parity |
| Buffered/Registered | Registered |
Align the notch with the motherboard slot key, press firmly until both retention clips click, then verify the BIOS recognises the module as registered ECC at 1.20 V; the step most often missed is enabling ECC in the firmware before first boot.
No scheduled maintenance is required; keep the contacts free of dust with compressed air and replace the module only if memory diagnostics report correctable or uncorrectable ECC errors.
The CAS latency of CL17 at 2400 MHz sets the timing ceiling; sustained throughput is bounded by the 19200 MB/s PC4-19200 rating and the registered buffer adds one cycle of command delay.
Tot din acest raion
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
În ce monedă plătiți și în ce monedă citiți prețurile.
Trimis din portofelul dumneavoastră la finalizarea comenzii
Doar pentru afișare — catalogul este exprimat în dolari
Nicio monedă nu corespunde.
Alegeți limba în care vă vorbește site-ul.
Prima vizită?
Aveți deja un cont?
Nu există o resetare automată: acest magazin nu trimite niciun e-mail, deci nu există niciun link de unică folosință de solicitat. Lăsați adresa în cont. Va fi tratată manual.
Cerere înregistrată
Nu veți primi nimic în căsuța de e-mail — acest magazin nu trimite niciun e-mail. Cineva se ocupă de asta manual.
V-ați amintit-o?