NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Mēs pieņemam kriptovalūtu — lai tā, kas Jums pieder, varētu nopirkt īstu aparatūru.Maksājiet kriptovalūtā, iztērējiet to īstai aparatūrai. Bezmaksas apdrošināta piegāde visā pasaulē virs 399 $. Vienkāršas, nemarķētas kastes, sūtītas no Vācijas.Bezmaksas apdrošināta piegāde virs 399 $. Jūsu kurss tiek fiksēts uz 30 minūtēm, tiklīdz atveras kase.Kurss fiksēts uz 30 minūtēm. Katra prece ir aizzīmogota, tās sērijas numurs ir pārbaudīts, un uz to attiecas 24 mēnešu garantija.Aizzīmogots, 24 mēnešu garantija.
Kingston Technology Corp.
Registered ECC DDR4 module with CL17 timing and 2400 MHz speed for server stability
This 8 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.20 V operation. It uses a registered design with parity ECC for error detection. The 288-pin DIMM fits standard desktop slots that support registered memory. It is built with Hynix D-Die for consistent stability.
Registered DIMMs include an on-module register that adds a small, constant power overhead compared with unbuffered sticks. The 1.20 V rating keeps heat output low during typical workloads. No active cooling is required on the module itself. System airflow normally handles the modest thermal load.
Parity ECC lets the memory controller detect single-bit errors before they corrupt data. The registered buffer reduces electrical load on the memory bus, which helps signal integrity when multiple modules are populated. These features target servers and workstations that prioritise uptime over raw latency. Builders who need unbuffered non-ECC memory for consumer platforms should choose a different module type.
| Brand | Kingston |
|---|---|
| Model | KSM24RS8/8HDI |
| Capacity | 8GB |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Parity |
| Buffered/Registered | Registered |
Align the notch with the motherboard slot key, press firmly until both retention clips click, then verify the BIOS recognises the module as registered ECC at 1.20 V; the step most often missed is enabling ECC in the firmware before first boot.
No scheduled maintenance is required; keep the contacts free of dust with compressed air and replace the module only if memory diagnostics report correctable or uncorrectable ECC errors.
The CAS latency of CL17 at 2400 MHz sets the timing ceiling; sustained throughput is bounded by the 19200 MB/s PC4-19200 rating and the registered buffer adds one cycle of command delay.
Arī šajā sadaļā
Tas pats plaukts, tā pati kase — astoņas kriptovalūtas un kursa fiksēšana uz 30 minūtēm.
Kriptovalūta, kurā maksājat, un valūta, kurā redzat cenas.
Nosūtīts no Jūsu maciņa, noformējot pasūtījumu
Tikai informatīvi — katalogā cenas norādītas ASV dolāros
Neviena valūta neatbilst.
Izvēlieties valodu, kurā vietne sarunājas ar Jums.
Pirmo reizi šeit?
Jau ir konts?
Automātiskas atiestatīšanas nav: šis veikals nesūta e-pastus, tāpēc nav arī vienreizējas saites, ko pieprasīt. Atstājiet adresi kontā, un tā tiks apstrādāta manuāli.
Pieprasījums saņemts
Uz Jūsu e-pastu nekas neatnāks — šis veikals vispār nesūta e-pastus. Kāds šos pieprasījumus apstrādā manuāli.
Atcerējāties?