Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green rectangular circuit board with black memory chips and gold edge connectors

Kingston Technology Corp.

Kingston Technology Corp. KSM24RS8/8HDI 8GB DDR4 2400MHz ECC Registered CL17 288-Pin DIMM 1Rx8 Hynix D-Die

SKU CH-TC5V-H1PEQ

Registered ECC DDR4 module with CL17 timing and 2400 MHz speed for server stability

  • Capacity8GB
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.20V
  • ECCParity
  • Buffered/RegisteredRegistered
  • ECC parity protects data integrity in critical workloads
  • Registered design stabilises signal for dense server configurations
  • DDR4 2400 speed delivers 19200 MT/s bandwidth
  • CL17 latency keeps response tight at 1.20 V
  • 288-pin DIMM fits standard DDR4 server slots

8 GB DDR4 2400 ECC Registered Module

This 8 GB DDR4 module runs at 2400 MHz with CL17 latency and 1.20 V operation. It uses a registered design with parity ECC for error detection. The 288-pin DIMM fits standard desktop slots that support registered memory. It is built with Hynix D-Die for consistent stability.

Thermals and Power Draw

Registered DIMMs include an on-module register that adds a small, constant power overhead compared with unbuffered sticks. The 1.20 V rating keeps heat output low during typical workloads. No active cooling is required on the module itself. System airflow normally handles the modest thermal load.

ECC and Registration Benefits

Parity ECC lets the memory controller detect single-bit errors before they corrupt data. The registered buffer reduces electrical load on the memory bus, which helps signal integrity when multiple modules are populated. These features target servers and workstations that prioritise uptime over raw latency. Builders who need unbuffered non-ECC memory for consumer platforms should choose a different module type.

Helstu kostir

  • ECC parity protects data integrity in critical workloads
  • Registered design stabilises signal for dense server configurations
  • DDR4 2400 speed delivers 19200 MT/s bandwidth
  • CL17 latency keeps response tight at 1.20 V
  • 288-pin DIMM fits standard DDR4 server slots

Tæknilýsing

BrandKingston
ModelKSM24RS8/8HDI
Capacity8GB
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.20V
ECCParity
Buffered/RegisteredRegistered

Spurningar um þessa vöru

How do I install this 288-pin registered DDR4 DIMM and what step is often missed?

Align the notch with the motherboard slot key, press firmly until both retention clips click, then verify the BIOS recognises the module as registered ECC at 1.20 V; the step most often missed is enabling ECC in the firmware before first boot.

What maintenance or replacement will this 8 GB DDR4 2400 MHz CL17 module need over time?

No scheduled maintenance is required; keep the contacts free of dust with compressed air and replace the module only if memory diagnostics report correctable or uncorrectable ECC errors.

What limit appears first when this registered ECC DDR4 2400 CL17 1.20 V DIMM runs sustained workloads?

The CAS latency of CL17 at 2400 MHz sets the timing ceiling; sustained throughput is bounded by the 19200 MB/s PC4-19200 rating and the registered buffer adds one cycle of command delay.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.