OWC 16GB (2x8GB) DDR4 2666MHz ECC SODIMM Memory Upgrade
- 16GB (2 x 8GB)
- 260-Pin DDR4 ECC SO…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
OWC
A 16 GB DDR4 2666 ECC SODIMM kit validated for Synology DS1621+ and DS1621xs+ NAS systems
Capacity 16GB (2 x 8GB)
This 16GB kit contains two 8GB DDR4 2666 SODIMM modules built for the Synology DiskStation DS1621+ and DS1621xs+. Each stick runs at 1.2V with CL19 latency and includes on-die ECC for data integrity. The 260-pin unbuffered design matches the factory memory slots in these NAS units.
The kit suits administrators expanding a DS1621+ or DS1621xs+ beyond the stock capacity while keeping error correction active. Systems that require registered DIMMs, non-ECC modules, or a different pin count cannot use this memory. Builders working on desktop PCs or laptops without ECC support should look elsewhere.
The modules operate at DDR4 2666 (PC4-21300) with a CAS latency of 19 and 1.2V voltage. JEDEC compliance allows backward compatibility with 2400MHz and 2133MHz bus speeds. This speed and latency combination determines whether the NAS will accept the upgrade without timing conflicts.
| Brand | OWC |
|---|---|
| Part Number | 2C6D41R8016P |
| Capacity | 16GB (2 x 8GB) |
| Type | 260-Pin DDR4 ECC SODIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | Synology DiskStationDS1621+ Synology DiskStationDS1621xs+ |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Power off the NAS, unplug it, open the chassis cover, insert each module at an angle until the gold contacts disappear, then press down firmly until both side clips click — the step most people miss is pressing hard enough to engage both clips.
No firmware updates are required for the memory itself; the modules are passive components with no moving parts and are rated for continuous operation at 1.2V, so they do not have a scheduled replacement interval.
The memory controller caps the data rate at 2666 MT/s, so sustained throughput is limited by the DDR4-2666 CL19 timing rather than thermals or voltage.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?