OWC 16GB (2x8GB) DDR4 2666MHz ECC SODIMM Memory Upgrade
- 16GB (2 x 8GB)
- 260-Pin DDR4 ECC SO…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
A 16 GB DDR4 2666 ECC SODIMM kit validated for Synology DS1621+ and DS1621xs+ NAS systems
Capacity 16GB (2 x 8GB)
This 16GB kit contains two 8GB DDR4 2666 SODIMM modules built for the Synology DiskStation DS1621+ and DS1621xs+. Each stick runs at 1.2V with CL19 latency and includes on-die ECC for data integrity. The 260-pin unbuffered design matches the factory memory slots in these NAS units.
The kit suits administrators expanding a DS1621+ or DS1621xs+ beyond the stock capacity while keeping error correction active. Systems that require registered DIMMs, non-ECC modules, or a different pin count cannot use this memory. Builders working on desktop PCs or laptops without ECC support should look elsewhere.
The modules operate at DDR4 2666 (PC4-21300) with a CAS latency of 19 and 1.2V voltage. JEDEC compliance allows backward compatibility with 2400MHz and 2133MHz bus speeds. This speed and latency combination determines whether the NAS will accept the upgrade without timing conflicts.
| Brand | OWC |
|---|---|
| Part Number | 2C6D41R8016P |
| Capacity | 16GB (2 x 8GB) |
| Type | 260-Pin DDR4 ECC SODIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | Synology DiskStationDS1621+ Synology DiskStationDS1621xs+ |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power off the NAS, unplug it, open the chassis cover, insert each module at an angle until the gold contacts disappear, then press down firmly until both side clips click — the step most people miss is pressing hard enough to engage both clips.
No firmware updates are required for the memory itself; the modules are passive components with no moving parts and are rated for continuous operation at 1.2V, so they do not have a scheduled replacement interval.
The memory controller caps the data rate at 2666 MT/s, so sustained throughput is limited by the DDR4-2666 CL19 timing rather than thermals or voltage.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?