OWC 16GB (2x8GB) DDR4 2666MHz ECC SODIMM Memory Upgrade
- 16GB (2 x 8GB)
- 260-Pin DDR4 ECC SO…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
A 16 GB DDR4 2666 ECC SODIMM kit validated for Synology DS1621+ and DS1621xs+ NAS systems
Capacity 16GB (2 x 8GB)
This 16GB kit contains two 8GB DDR4 2666 SODIMM modules built for the Synology DiskStation DS1621+ and DS1621xs+. Each stick runs at 1.2V with CL19 latency and includes on-die ECC for data integrity. The 260-pin unbuffered design matches the factory memory slots in these NAS units.
The kit suits administrators expanding a DS1621+ or DS1621xs+ beyond the stock capacity while keeping error correction active. Systems that require registered DIMMs, non-ECC modules, or a different pin count cannot use this memory. Builders working on desktop PCs or laptops without ECC support should look elsewhere.
The modules operate at DDR4 2666 (PC4-21300) with a CAS latency of 19 and 1.2V voltage. JEDEC compliance allows backward compatibility with 2400MHz and 2133MHz bus speeds. This speed and latency combination determines whether the NAS will accept the upgrade without timing conflicts.
| Brand | OWC |
|---|---|
| Part Number | 2C6D41R8016P |
| Capacity | 16GB (2 x 8GB) |
| Type | 260-Pin DDR4 ECC SODIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | Synology DiskStationDS1621+ Synology DiskStationDS1621xs+ |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Power off the NAS, unplug it, open the chassis cover, insert each module at an angle until the gold contacts disappear, then press down firmly until both side clips click — the step most people miss is pressing hard enough to engage both clips.
No firmware updates are required for the memory itself; the modules are passive components with no moving parts and are rated for continuous operation at 1.2V, so they do not have a scheduled replacement interval.
The memory controller caps the data rate at 2666 MT/s, so sustained throughput is limited by the DDR4-2666 CL19 timing rather than thermals or voltage.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟