Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.

Praćeni artikli Prijava
Green development board with dual male headers and rubber feet

Pimoroni

Pimoroni PIM556 PICO Omnibus Dual Expander development board

SKU CH-N7QB-70BAP

Connect two Pico Packs or Bases to a single Raspberry Pi Pico with labelled headers and rubber feet included

  • Attach two Pico add-ons simultaneously using dual male header landing areas
  • Prototype with jumper wires or circuitry via extra labelled male GPIO pins
  • Identify connections quickly with clearly labelled female and mirrored male headers
  • Ready to use in minutes as the board arrives 99% assembled with only feet to attach
  • Stable bench setup provided by four included rubber feet

Dual Pico Add-On Expansion Board

The Pimoroni PIM556 PICO Omnibus Dual Expander is a development board that connects two Pico Packs or Bases to a single Raspberry Pi Pico. It arrives fully assembled with labelled headers and rubber feet, so no soldering is required before use.

Makers needing simultaneous add-on access

This board suits developers who want to run two add-ons at once or route extra GPIO signals to jumper wires and prototype circuits. Builders who only ever use one add-on at a time will not need the extra connectors.

Two add-on landing areas with mirrored male headers

The key specification is the pair of mirrored male header zones that accept two add-ons in parallel. If your project requires only a single add-on connection, this dual layout provides no advantage.

Istaknuto

  • Attach two Pico add-ons simultaneously using dual male header landing areas
  • Prototype with jumper wires or circuitry via extra labelled male GPIO pins
  • Identify connections quickly with clearly labelled female and mirrored male headers
  • Ready to use in minutes as the board arrives 99% assembled with only feet to attach
  • Stable bench setup provided by four included rubber feet

Specifikacije

Za ovaj artikl još nisu objavljene specifikacije.

Pitanja o ovom artiklu

What physical space does the PIM556 board need for its rubber feet?

Four adhesive rubber feet are included to stabilise the board on a flat surface; simply peel and stick them to the corners of the underside.

How is the PIM556 connected to a Raspberry Pi Pico, and what step is often missed?

Press the Pico onto the labelled female headers; the board arrives 99% assembled so only the rubber feet need fitting — forgetting the feet is the common oversight.

What ongoing maintenance does the PIM556 require after installation?

No scheduled maintenance is needed; the board has no moving parts or consumables, so it simply remains in place while you swap Pico Packs or jumper wires as required.

Također u ovoj kategoriji

Kupci su usporedili ovo

Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.