Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Green development board with dual male headers and rubber feet

Pimoroni

Pimoroni PIM556 PICO Omnibus Dual Expander development board

SKU CH-N7QB-70BAP

Connect two Pico Packs or Bases to a single Raspberry Pi Pico with labelled headers and rubber feet included

  • Attach two Pico add-ons simultaneously using dual male header landing areas
  • Prototype with jumper wires or circuitry via extra labelled male GPIO pins
  • Identify connections quickly with clearly labelled female and mirrored male headers
  • Ready to use in minutes as the board arrives 99% assembled with only feet to attach
  • Stable bench setup provided by four included rubber feet

Dual Pico Add-On Expansion Board

The Pimoroni PIM556 PICO Omnibus Dual Expander is a development board that connects two Pico Packs or Bases to a single Raspberry Pi Pico. It arrives fully assembled with labelled headers and rubber feet, so no soldering is required before use.

Makers needing simultaneous add-on access

This board suits developers who want to run two add-ons at once or route extra GPIO signals to jumper wires and prototype circuits. Builders who only ever use one add-on at a time will not need the extra connectors.

Two add-on landing areas with mirrored male headers

The key specification is the pair of mirrored male header zones that accept two add-ons in parallel. If your project requires only a single add-on connection, this dual layout provides no advantage.

Poudarki

  • Attach two Pico add-ons simultaneously using dual male header landing areas
  • Prototype with jumper wires or circuitry via extra labelled male GPIO pins
  • Identify connections quickly with clearly labelled female and mirrored male headers
  • Ready to use in minutes as the board arrives 99% assembled with only feet to attach
  • Stable bench setup provided by four included rubber feet

Specifikacije

Za ta izdelek še ni objavljenih specifikacij.

Vprašanja o tem izdelku

What physical space does the PIM556 board need for its rubber feet?

Four adhesive rubber feet are included to stabilise the board on a flat surface; simply peel and stick them to the corners of the underside.

How is the PIM556 connected to a Raspberry Pi Pico, and what step is often missed?

Press the Pico onto the labelled female headers; the board arrives 99% assembled so only the rubber feet need fitting — forgetting the feet is the common oversight.

What ongoing maintenance does the PIM556 require after installation?

No scheduled maintenance is needed; the board has no moving parts or consumables, so it simply remains in place while you swap Pico Packs or jumper wires as required.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.