NEMIX RAM 64GB 4x16GB DDR4 2933MHz CL21 1Rx8 UDIMM memory upgrade
- 64GB (4 x 16GB)
- 288-Pin DDR4 UDIMM
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
NEMIX RAM
A 32 GB kit of four 8 GB DDR5 modules running at 5600 MT/s with CL46 latency and 1.1 V for the Supermicro X13SAW-F motherboard
Size 32GB 4X8GB
This 32 GB kit provides four 8 GB DDR5 UDIMMs rated at 5600 MT/s with CL46 latency and 1.10 V operation. The modules use 1Rx8 non-ECC unbuffered chips from major OEM suppliers and match the 288-pin layout the motherboard requires.
When a system shows reduced capacity or runs at lower speeds because of mixed ranks or voltages, this kit restores the full 32 GB at the board's native 5600 MT/s rating. The jump is worth it if the current memory does not meet the exact 1Rx8, 1.10 V, CL46 specification.
Buyers who need ECC error correction, registered modules, SODIMM form factor, or a different speed grade should look elsewhere. This kit is built only for non-ECC unbuffered desktop configurations that accept the stated timing and voltage.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 Non-ECC Unbuffered UDIMM Memory |
| Part Number | MD44800-818K4 |
| Capacity | 32GB (4 x 8GB) |
| Type | 288-Pin DDR5 UDIMM |
| Speed | DDR5 5600 (PC5 44800) |
| CAS Latency | CL46 |
| Voltage | 1.10V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 32GB 4X8GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
Yes, the kit uses the 288-pin DDR5 UDIMM form factor that the X13SAW-F requires, so each module seats directly in the board's standard DIMM sockets.
Install the modules in the exact slot sequence shown in the Supermicro X13SAW-F manual; the board's memory-population rules determine which channels activate first and must be followed for all four sticks to be recognised.
No firmware or driver is required; the modules run at the rated DDR5 5600 CL46 1.1V settings once the system boots, provided the motherboard BIOS is current enough to support the memory controller.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?