Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Small square blue pushbutton with illuminated power symbol, breadboard compatible

Adafruit

Adafruit Mini Illuminated Momentary Pushbutton Blue Power Symbol

SKU CH-DSAC-7VPMT

A breadboard-friendly momentary tactile switch with a built-in LED that shines through a universal power symbol, rated 12 V and 50 mA for the switch contacts

  • TypePrototyping Products
  • Breadboard-ready 9.8 mm diameter fits protoboards
  • Built-in LED shines through blue power symbol
  • Momentary action gives tactile press without latching
  • Switch rated 12 V and 50 mA for logic circuits
  • LED runs at ~10 mA with external resistor

Breadboard-friendly illuminated button

This Adafruit Mini Illuminated Momentary Pushbutton adds a tactile switch with a built-in LED and a universal power symbol to your project. It snaps into a standard breadboard for quick prototyping. The switch is rated for 12V and 50mA while the LED draws about 10mA. It suits hobbyists and engineers building custom control panels.

Momentary action requires external LED control

The button is momentary, not a latching on-off switch, so it only closes the circuit while pressed. The LED is electrically separate from the switch contacts and includes no current-limiting resistor. You must add a roughly 1K resistor and drive the LED from a microcontroller pin or other source. The cathode is the pin nearest the line half of the power symbol.

Simple breadboard install with wiring caveats

The 9.8mm diameter body fits a breadboard directly and the 8mm height keeps a low profile. Installation is straightforward, but forgetting the external resistor will damage the LED. Wiring the LED polarity incorrectly will also prevent it from lighting. Builders needing a maintained on-off switch or a pre-wired indicator should choose a different component.

Helstu kostir

  • Breadboard-ready 9.8 mm diameter fits protoboards
  • Built-in LED shines through blue power symbol
  • Momentary action gives tactile press without latching
  • Switch rated 12 V and 50 mA for logic circuits
  • LED runs at ~10 mA with external resistor

Tæknilýsing

TypePrototyping Products

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.