Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Small square blue pushbutton with illuminated power symbol, breadboard compatible

Adafruit

Adafruit Mini Illuminated Momentary Pushbutton Blue Power Symbol

SKU CH-DSAC-7VPMT

A breadboard-friendly momentary tactile switch with a built-in LED that shines through a universal power symbol, rated 12 V and 50 mA for the switch contacts

  • TypePrototyping Products
  • Breadboard-ready 9.8 mm diameter fits protoboards
  • Built-in LED shines through blue power symbol
  • Momentary action gives tactile press without latching
  • Switch rated 12 V and 50 mA for logic circuits
  • LED runs at ~10 mA with external resistor

Breadboard-friendly illuminated button

This Adafruit Mini Illuminated Momentary Pushbutton adds a tactile switch with a built-in LED and a universal power symbol to your project. It snaps into a standard breadboard for quick prototyping. The switch is rated for 12V and 50mA while the LED draws about 10mA. It suits hobbyists and engineers building custom control panels.

Momentary action requires external LED control

The button is momentary, not a latching on-off switch, so it only closes the circuit while pressed. The LED is electrically separate from the switch contacts and includes no current-limiting resistor. You must add a roughly 1K resistor and drive the LED from a microcontroller pin or other source. The cathode is the pin nearest the line half of the power symbol.

Simple breadboard install with wiring caveats

The 9.8mm diameter body fits a breadboard directly and the 8mm height keeps a low profile. Installation is straightforward, but forgetting the external resistor will damage the LED. Wiring the LED polarity incorrectly will also prevent it from lighting. Builders needing a maintained on-off switch or a pre-wired indicator should choose a different component.

Přednosti

  • Breadboard-ready 9.8 mm diameter fits protoboards
  • Built-in LED shines through blue power symbol
  • Momentary action gives tactile press without latching
  • Switch rated 12 V and 50 mA for logic circuits
  • LED runs at ~10 mA with external resistor

Specifikace

TypePrototyping Products

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.