Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Silver 2.5 inch SAS hard drive with green circuit board visible

DELL

DELL AL13SXB300N 300GB 15000RPM 2.5" SAS internal hard drive

SKU CH-7YTR-2MGA8 MPN AL13SXB300N

300 GB enterprise SAS drive spinning at 15,000 RPM in a 2.5-inch form factor

  • 300 GB capacity stores large enterprise datasets
  • 15 000 RPM spindle delivers fast transactional throughput
  • SAS interface provides dual-port reliability for servers
  • 5 inch form factor fits dense SFF bays
  • New condition ensures full manufacturer specification compliance

Enterprise SAS Drive

The Dell AL13SXB300N is a 300GB enterprise hard drive built for servers and storage arrays that demand consistent throughput. Its 15000RPM spindle speed suits transaction-heavy workloads and database tiers where low latency matters more than raw capacity.

2.5-Inch SAS Connector

The 2.5-inch form factor fits small-form-factor bays and hot-swap backplanes using a standard SAS interface. Dual-port SAS connectivity enables multipath I/O for redundancy, while the 6Gb/s link speed matches common HBA and RAID controller ports.

No Accessories Included

The drive ships as a bare unit without cables, brackets, mounting screws or management software. System integrators must supply compatible SAS cables, drive carriers and any firmware tools required by their specific server or storage platform.

Helstu kostir

  • 300 GB capacity stores large enterprise datasets
  • 15 000 RPM spindle delivers fast transactional throughput
  • SAS interface provides dual-port reliability for servers
  • 5 inch form factor fits dense SFF bays
  • New condition ensures full manufacturer specification compliance

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

What throughput limit does the 6 Gb/s SAS interface impose on this 300 GB drive?

The SAS 6 Gb/s link caps the maximum burst rate at the interface level; sustained transfer will be lower and depends on the 15000 RPM mechanical performance.

Which drive bay and connector spacing does the 2.5-inch SFF form factor require?

It fits a standard 2.5-inch SAS/SATA hot-plug bay with the SFF 29-pin connector; no 3.5-inch adapter is included.

How is the drive installed in a Dell server, and what step is often missed?

Slide the carrier into the hot-plug bay until the latch clicks, then verify the SAS cable is fully seated on the backplane — the latch click alone does not guarantee electrical contact.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.