暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Silver 2.5 inch SAS hard drive with green circuit board visible

DELL

DELL AL13SXB300N 300GB 15000RPM 2.5" SAS internal hard drive

SKU CH-7YTR-2MGA8 MPN AL13SXB300N

300 GB enterprise SAS drive spinning at 15,000 RPM in a 2.5-inch form factor

  • 300 GB capacity stores large enterprise datasets
  • 15 000 RPM spindle delivers fast transactional throughput
  • SAS interface provides dual-port reliability for servers
  • 5 inch form factor fits dense SFF bays
  • New condition ensures full manufacturer specification compliance

Enterprise SAS Drive

The Dell AL13SXB300N is a 300GB enterprise hard drive built for servers and storage arrays that demand consistent throughput. Its 15000RPM spindle speed suits transaction-heavy workloads and database tiers where low latency matters more than raw capacity.

2.5-Inch SAS Connector

The 2.5-inch form factor fits small-form-factor bays and hot-swap backplanes using a standard SAS interface. Dual-port SAS connectivity enables multipath I/O for redundancy, while the 6Gb/s link speed matches common HBA and RAID controller ports.

No Accessories Included

The drive ships as a bare unit without cables, brackets, mounting screws or management software. System integrators must supply compatible SAS cables, drive carriers and any firmware tools required by their specific server or storage platform.

特長

  • 300 GB capacity stores large enterprise datasets
  • 15 000 RPM spindle delivers fast transactional throughput
  • SAS interface provides dual-port reliability for servers
  • 5 inch form factor fits dense SFF bays
  • New condition ensures full manufacturer specification compliance

仕様

この商品の仕様はまだ公開されていません。

この商品に関する質問

What throughput limit does the 6 Gb/s SAS interface impose on this 300 GB drive?

The SAS 6 Gb/s link caps the maximum burst rate at the interface level; sustained transfer will be lower and depends on the 15000 RPM mechanical performance.

Which drive bay and connector spacing does the 2.5-inch SFF form factor require?

It fits a standard 2.5-inch SAS/SATA hot-plug bay with the SFF 29-pin connector; no 3.5-inch adapter is included.

How is the drive installed in a Dell server, and what step is often missed?

Slide the carrier into the hot-plug bay until the latch clicks, then verify the SAS cable is fully seated on the backplane — the latch click alone does not guarantee electrical contact.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。