Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn

NEMIX RAM

NEMIX RAM 1.5TB 16x96GB DDR5 4800 CL40 2Rx4 1.1V ECC RDIMM H13DSH memory upgrade

SKU CH-EDCQ-F3HZK

1.5 TB kit of 16 DDR5 96 GB registered ECC RDIMMs at 4800 MT/s, CL40, 1.1 V, validated for the Supermicro H13DSH motherboard

  • Capacity1.5TB (16 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • 5 TB capacity across 16 modules of 96 GB each
  • DDR5 4800 speed with CL40 latency at 1.1 V
  • Registered ECC RDIMM architecture for full-slot stability
  • 288-pin 2Rx4 form factor matched to Supermicro H13DSH
  • Major OEM Samsung, Micron or Hynix chips for enterprise reliability

System-specific DDR5 server memory kit

This NEMIX RAM kit provides 1.5 TB of DDR5-4800 registered ECC memory in a 16-module configuration of 96 GB each. It is built for the Supermicro H13DSH motherboard and matches the exact rank, voltage and timing the platform expects.

Sustained-load behaviour with registered ECC

Registered architecture buffers the address and command signals so all 16 slots can run fully populated at the rated 4800 MT/s without overloading the memory controller. On-die ECC detects and corrects single-bit errors during continuous operation, preventing silent data corruption that would otherwise cause unplanned downtime.

Pre-installation checks for the H13DSH platform

Verify the motherboard manual for approved DIMM population order, maximum supported capacity per socket and any BIOS version requirements before ordering. The 288-pin RDIMM form factor is mandatory; UDIMM or SODIMM modules will not fit and the kit will not function in platforms that require a different memory type.

Helstu kostir

  • 5 TB capacity across 16 modules of 96 GB each
  • DDR5 4800 speed with CL40 latency at 1.1 V
  • Registered ECC RDIMM architecture for full-slot stability
  • 288-pin 2Rx4 form factor matched to Supermicro H13DSH
  • Major OEM Samsung, Micron or Hynix chips for enterprise reliability

Tæknilýsing

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K16
Capacity1.5TB (16 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content1.5TB 16X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

How much power does the 1.5TB kit draw when the server runs continuously?

Each 96GB module operates at 1.1V, so the full 16-DIMM kit runs at that voltage; total wattage depends on the Supermicro H13DSH memory controller load.

What motherboard and CPU combination must I already have for this 16x96GB kit to function?

The kit is validated for the Supermicro H13DSH motherboard; you need a compatible CPU that supports DDR5-4800 Registered ECC RDIMMs and 16 populated slots.

Can I mix these 2Rx4 CL40 RDIMMs with existing DDR5 modules of different rank or latency on the H13DSH?

The H13DSH memory population rules require matching rank, voltage and timing across all slots; mixing different 2Rx4 CL40 1.1V modules may prevent the full 1.5TB from being recognised.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.