Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Black square 60mm CPU cooler fan with 2-pin connector

OEM Industries

OEM Industries KD1206PHS2 60mm 12V 1.9W 2-Pin CPU cooler

SKU CH-N5KM-C165X

A 60 mm square fan cooler running at 12 V and 1.9 W with a 2-pin connector

  • ColorBlack
  • TypeFan only
  • Fan Size60mm
  • Bearing TypeSleeve Bearing
  • Power Connector2 Pin
  • LEDNo
  • Compact 60 mm frame fits tight chassis
  • 12 V 1.9 W draw keeps power use low
  • Two-pin connector enables simple motherboard hookup
  • Sleeve bearing runs quietly at idle
  • Square cooler design directs airflow over CPU

Compact 60 mm square cooler

The OEM Industries KD1206PHS2 is a 60 mm square fan designed for direct CPU or case cooling. It runs on 12 V and draws 1.9 W through a two-pin power connector. A sleeve bearing keeps the assembly simple and cost-effective.

Suits tight spaces and low-power builds

This cooler fits small-form-factor chassis or legacy sockets where a 60 mm footprint is required. Builders needing higher airflow, PWM speed control or quiet operation at load should consider larger alternatives.

Mounts in standard 60 mm cut-outs

The fan installs in any 60 mm square mounting pattern without additional brackets. Its two-pin lead connects directly to a motherboard header or fan controller, leaving four-pin headers free for PWM devices. No LED lighting means no extra cables to route.

Helstu kostir

  • Compact 60 mm frame fits tight chassis
  • 12 V 1.9 W draw keeps power use low
  • Two-pin connector enables simple motherboard hookup
  • Sleeve bearing runs quietly at idle
  • Square cooler design directs airflow over CPU

Tæknilýsing

ModelKD1206PHS2
ColorBlack
TypeFan only
Fan Size60mm
Bearing TypeSleeve Bearing
Power Connector2 Pin
LEDNo

Spurningar um þessa vöru

Does my motherboard need a 2-pin fan header to run the KD1206PHS2 cooler?

Yes, the cooler uses a 2-pin power connector, so your board must provide a matching 2-pin fan header.

Will the 60 mm square frame of this cooler clear the mounting holes on my older socket board?

The cooler has a 60 mm square footprint; check your board’s mounting-hole spacing against those dimensions before installing.

How can I confirm the 12 V 1.9 W fan is spinning correctly after I fit it?

Power the system and verify the fan rotates; you can also monitor the fan speed in the BIOS or a hardware-monitoring utility.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.