Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Green 240-pin DDR3L ECC registered DIMM module

OWC

OWC 8GB DDR3L 1600 ECC Registered RDIMM 2Rx4 1.35V Cisco UCS C200 M2 C210 M2

SKU CH-D037-6NK20

8GB DDR3L 1600 ECC registered RDIMM for Cisco UCS C200 M2 and C210 M2 servers

  • Capacity8GB
  • Type240-Pin DDR3L ECC RDIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes

Capacity 8GB

  • ECC registered design protects data integrity in servers
  • 35V DDR3L reduces power draw versus standard DDR3
  • 1600 MHz CL11 speed matches Cisco UCS C200 M2 and C210 M2 specs
  • Single 8 GB 2Rx4 module simplifies capacity upgrades
  • 240-pin RDIMM form factor fits validated workstation and server slots

Server-specific 8 GB DDR3L RDIMM

This 8 GB DDR3L 1600 registered ECC module is built for Cisco UCS C200 M2 and C210 M2 servers. It operates at 1.35 V with CL11 latency and a 2Rx4 organisation on a 240-pin form factor. The part targets administrators who need to expand memory capacity in those exact platforms.

Replaces Cisco UCSMR1X082RYA

The module serves as a direct replacement for the Cisco part number UCSMR1X082RYA. The upgrade is worthwhile when the server currently runs with fewer registered ECC DIMMs or when a failed stick must be swapped without mixing registered and unbuffered or load-reduced memory types.

Simple DIMM installation

Installation follows the standard 240-pin DIMM procedure: power down, open the chassis, align the notch, and press until the latches click. The main risk is inserting the module into a system that expects unbuffered or load-reduced memory, which will prevent boot or cause instability.

Helstu kostir

  • ECC registered design protects data integrity in servers
  • 35V DDR3L reduces power draw versus standard DDR3
  • 1600 MHz CL11 speed matches Cisco UCS C200 M2 and C210 M2 specs
  • Single 8 GB 2Rx4 module simplifies capacity upgrades
  • 240-pin RDIMM form factor fits validated workstation and server slots

Tæknilýsing

BrandOWC
Part Number1R6T32R408GB
Capacity8GB
Type240-Pin DDR3L ECC RDIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Heat SpreaderNo
Compatible SystemCisco UCS C200 M2
Cisco UCS C210 M2

Aðrar útgáfur af þessari vöru

5 í viðbót í sama vöruflokki

Sama fjölskylda, mismunandi minni, kælingu eða klukkuhraða — berðu saman áður en þú ákveður þig.

Spurningar um þessa vöru

Will the 240-pin DDR3L RDIMM fit the memory slots in my Cisco UCS C200 M2 or C210 M2 server?

Yes, the module uses the standard 240-pin DDR3L RDIMM form factor required by both the C200 M2 and C210 M2.

What is the correct way to install this ECC registered DIMM, and what common mistake should I avoid?

Power down the server, open the chassis, align the notch on the 240-pin module with the slot key, and press firmly until the retention clips lock; do not mix this registered ECC DIMM with unbuffered or load-reduced memory.

When will this 8GB DDR3L 1600 module need replacement, and what should I look for?

The module is built to JEDEC and RoHS standards with a limited lifetime warranty; replace it only if memory diagnostics report uncorrectable ECC errors or the server fails to recognise the DIMM at POST.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.