Við tökum við rafmynt — svo myntirnar sem þú átt geta keypt alvöru vélbúnað.Greiddu í rafmynt, eyddu henni í alvöru vélbúnað. Frí, tryggð sending um allan heim fyrir pantanir yfir 399 $. Hlutlausir pappakassar án merkinga, sendir frá Þýskalandi.Frí, tryggð sending yfir 399 $. Gengið þitt er læst í 30 mínútur um leið og greiðsluferlið hefst.Gengið læst í 30 mínútur. Hver vara er innsigluð, raðnúmer hennar yfirfarið, og hún nýtur 24 mánaða ábyrgðar.Innsiglað, með 24 mánaða ábyrgð.

Vaktaðar vörur Skrá inn
Compact green circuit board with CF slot and 50-pin 1.8-inch IDE connector

SMUGDESK

SMUGDESK CF to 50Pin 1.8" IDE SSD Adapter

SKU CH-0TCQ-QY75E

Converts a standard CF card into a solid-state 50-pin 1.8-inch IDE drive for legacy notebook and industrial system upgrades

  • Converts CF cards to 50pin 1.8inch IDE interface
  • Solidstate replacement removes mechanical failure risk from aging HDDs
  • Compact form factor matches 1.8inch mounting for direct dropin fit
  • Vibrationresistant flash storage has no moving parts for industrial use
  • Driverfree plugandplay works with legacy notebooks and embedded systems

CF to 1.8" IDE adapter for legacy upgrades

This adapter converts a standard CompactFlash card into a 50-pin 1.8-inch IDE solid-state drive. It targets technicians repairing vintage notebooks, industrial controllers, or embedded systems that still rely on the 1.8-inch form factor. The unit serves as a direct mechanical replacement for failed spinning disks.

Limited to 50-pin 1.8-inch IDE only

The connector fits exclusively 50-pin 1.8-inch IDE ports and will not mate with 2.5-inch IDE interfaces. Only standard CF cards are accepted; CFast, SD, and microSD media are not supported. No drivers are required for most legacy operating systems, but the host must provide a native 1.8-inch IDE channel.

50-pin 1.8-inch IDE interface decides fit

Verify that the target device uses a 50-pin 1.8-inch IDE hard-drive socket before ordering. The adapter’s physical dimensions match the 1.8-inch mounting pattern for drop-in installation. If the system uses any other interface, this part will not work.

Helstu kostir

  • Converts CF cards to 50pin 1.8inch IDE interface
  • Solidstate replacement removes mechanical failure risk from aging HDDs
  • Compact form factor matches 1.8inch mounting for direct dropin fit
  • Vibrationresistant flash storage has no moving parts for industrial use
  • Driverfree plugandplay works with legacy notebooks and embedded systems

Tæknilýsing

Engin birt tæknilýsing fyrir þessa vöru enn.

Spurningar um þessa vöru

Which CF card capacity should I choose for this 50pin 1.8inch IDE adapter?

The adapter accepts any standard Compact Flash card; select a capacity that matches the storage needs of your legacy notebook or embedded system.

What does the 1.8inch form factor mean once the adapter is installed in my device?

It matches the original 1.8inch IDE drive dimensions, so the adapter drops directly into the drive bay without brackets or modifications.

Will this 50pin IDE interface work with a 2.5inch IDE port on my laptop?

No, the adapter is built exclusively for 50pin 1.8inch IDE ports and will not fit 2.5inch IDE interfaces.

Einnig í þessum vöruflokki

Fólk bar þetta saman

Sama hilla, sama greiðsluferli — átta myntir og 30 mínútna gengislæsing.