OWC 8GB DDR4 3200MHz CL22 1.2V 288-pin UDIMM memory upgrade
- 8GB
- 288-Pin DDR4 Non-EC…
Priimame kriptovaliutą — taip monetos, kurias turite, gali nupirkti tikrą techniką.Mokėkite kriptovaliuta, išleiskite ją tikrai technikai. Nemokamas apdraustas pristatymas visame pasaulyje virš 399 $. Paprastos, be žymų siuntos dėžės, siunčiamos iš Vokietijos.Nemokamas apdraustas pristatymas virš 399 $. Jūsų kursas fiksuojamas 30 minučių, kai tik prasideda atsiskaitymas.Kursas fiksuojamas 30 minučių. Kiekvienas gaminys užplombuotas, jo serijos numeris patikrintas, ir jam taikoma 24 mėnesių garantija.Užplombuota, 24 mėnesių garantija.
OWC
8GB DDR4 2666 ECC UDIMM with CL19 latency and 1.2V operation, validated for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 NAS systems
This 8GB DDR4 2666 CL19 ECC unbuffered module is built for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 systems. It adds capacity while maintaining data integrity through error-correcting code. The single-rank 1Rx8 design fits standard 288-pin DIMM slots. It replaces QNAP part number RAM-8GDR4ECT0-UD-2666 directly.
The module operates at 1.2 volts and meets JEDEC PC4-21300 specifications for broad compatibility. It is backward compatible with 2133MHz and 2400MHz bus speeds. The bare circuit board allows installation in tight NAS chassis where tall heat spreaders would block adjacent slots or airflow. No extra power connectors or tools are required for the upgrade.
Confirm the exact model number matches the supported list above. Check how many memory slots your unit has populated and the maximum capacity per slot allowed by the firmware. Ensure the system accepts unbuffered ECC UDIMMs rather than registered or load-reduced variants. This module is not suitable for platforms that require registered memory or non-ECC consumer DIMMs.
| Brand | OWC |
|---|---|
| Part Number | 2E6D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | QNAP TS-h1283XU-RP QNAP TS-h1683XU-RP QNAP TS-h2483XU-RP QNAP TS-h686 QNAP TS-h886 |
Kiti šio modelio variantai
Ta pati šeima, bet skiriasi atmintis, aušintuvas ar dažnis — palyginkite prieš apsispręsdami.
The module is rated for 2666 MHz PC4-21300 CL19 at 1.2 V; the listed QNAP models accept this speed natively, so it will operate at the full 2666 MHz data rate.
Yes, the stick uses the standard 288-pin UDIMM form factor with no heat spreader, matching the slot keying and height clearance of the TS-h686 and TS-h886 NAS units.
Power off the NAS, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then power on and verify 8 GB in the system information.
Taip pat šiame skyriuje
Ta pati lentyna, tas pats atsiskaitymas — aštuonios monetos ir 30 minučių fiksuotas kursas.
Tai, kuo mokate, ir valiuta, kuria matote kainas.
Išsiunčiama iš Jūsų piniginės atsiskaitant
Tik rodoma — katalogo kainos nurodytos doleriais
Tokios valiutos nerasta.
Pasirinkite kalbą, kuria Jums kalbės svetainė.
Pirmą kartą čia?
Jau turite paskyrą?
Automatinio atstatymo nėra: ši parduotuvė nesiunčia jokių el. laiškų, todėl nėra jokios vienkartinės nuorodos, kurios būtų galima paprašyti. Palikite adresą paskyroje, ir juo bus pasirūpinta rankiniu būdu.
Prašymas užfiksuotas
Į Jūsų pašto dėžutę niekas nekeliauja — ši parduotuvė apskritai nesiunčia jokių el. laiškų. Šiuos prašymus kažkas peržiūri rankiniu būdu.
Prisiminėte?