OWC 8GB DDR4 3200MHz CL22 1.2V 288-pin UDIMM memory upgrade
- 8GB
- 288-Pin DDR4 Non-EC…
Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.
OWC
8GB DDR4 2666 ECC UDIMM with CL19 latency and 1.2V operation, validated for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 NAS systems
This 8GB DDR4 2666 CL19 ECC unbuffered module is built for QNAP TS-h1283XU-RP, TS-h1683XU-RP, TS-h2483XU-RP, TS-h686 and TS-h886 systems. It adds capacity while maintaining data integrity through error-correcting code. The single-rank 1Rx8 design fits standard 288-pin DIMM slots. It replaces QNAP part number RAM-8GDR4ECT0-UD-2666 directly.
The module operates at 1.2 volts and meets JEDEC PC4-21300 specifications for broad compatibility. It is backward compatible with 2133MHz and 2400MHz bus speeds. The bare circuit board allows installation in tight NAS chassis where tall heat spreaders would block adjacent slots or airflow. No extra power connectors or tools are required for the upgrade.
Confirm the exact model number matches the supported list above. Check how many memory slots your unit has populated and the maximum capacity per slot allowed by the firmware. Ensure the system accepts unbuffered ECC UDIMMs rather than registered or load-reduced variants. This module is not suitable for platforms that require registered memory or non-ECC consumer DIMMs.
| Brand | OWC |
|---|---|
| Part Number | 2E6D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC UDIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | QNAP TS-h1283XU-RP QNAP TS-h1683XU-RP QNAP TS-h2483XU-RP QNAP TS-h686 QNAP TS-h886 |
Alte versiuni ale acestui model
Aceeași familie, memorie, radiator sau frecvență diferite — comparați înainte de a vă decide.
The module is rated for 2666 MHz PC4-21300 CL19 at 1.2 V; the listed QNAP models accept this speed natively, so it will operate at the full 2666 MHz data rate.
Yes, the stick uses the standard 288-pin UDIMM form factor with no heat spreader, matching the slot keying and height clearance of the TS-h686 and TS-h886 NAS units.
Power off the NAS, open the chassis, align the notch on the 288-pin edge connector with the slot key, press firmly until both retention clips click, then power on and verify 8 GB in the system information.
Tot din acest raion
Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.
În ce monedă plătiți și în ce monedă citiți prețurile.
Trimis din portofelul dumneavoastră la finalizarea comenzii
Doar pentru afișare — catalogul este exprimat în dolari
Nicio monedă nu corespunde.
Alegeți limba în care vă vorbește site-ul.
Prima vizită?
Aveți deja un cont?
Nu există o resetare automată: acest magazin nu trimite niciun e-mail, deci nu există niciun link de unică folosință de solicitat. Lăsați adresa în cont. Va fi tratată manual.
Cerere înregistrată
Nu veți primi nimic în căsuța de e-mail — acest magazin nu trimite niciun e-mail. Cineva se ocupă de asta manual.
V-ați amintit-o?